Audiovox PRO 9246CH دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Model PRO 9246CH
Owner's Manual
Active/Passive Operation
Remote Keyless Entry
CONGRATULATIONS! Your purchase of this state-of-the-art security system expresses a
deep concern for the security of your vehicle, its contents, and passengers. To fully appreciate
the many functions and safeguards incorporated in this system, please spend a few minutes
reading this manual. You may find unexpected features that could mean the difference
between “protected” and “fully protected”
IMPORTANT ! In order

ملخص المحتوى في الصفحة رقم 2

NOTE: Because this system has an optional horn annunciation circuit, where light flash is mentioned, the horn may also beep a tone pattern synonymous with the flash pattern of the lights. Locking / Arming (Active) 1. Turn off the engine, exit the vehicle, and close all doors. 2. Press and release the Lock button on the keychain transmitter. The doors will lock, the LED will begin to flash slowly and the vehicle’s parking lamps will flash once, if the optional parking light flasher was added.

ملخص المحتوى في الصفحة رقم 3

NOTE: If the optional 2-step unlock feature was installed, then only the driver's door will unlock during step 1 above. To unlock all doors, press the unlock button of the transmitter a second time. 3. Never attempt to disarm the system from a distance that prevents you from opening a door within 30 seconds, when the system is programmed for passive arming as the system will begin to re-arm until a door is opened. Opening the door will suspend the passive arming cycle. CAR FINDER: As an added

ملخص المحتوى في الصفحة رقم 4

Programming Your Custom Override Code: Unlike override switches easily found, and defeated, this security system allows the consumer to program a personal override code, offering a higher level of security. To take advantage of this option, programmable feature # 6 must be selected for the Custom Code Option. Consult your installation center for programming details. The system comes from the factory with a pre-programmed override code of 11. To change this default override code, do the follo

ملخص المحتوى في الصفحة رقم 5

7. Within 10 seconds, begin to press and release the push button switch to set the units digit. (As per the example, press and release 2 times to set the units digit to 2). 8. Turn the ignition switch to the off position. Immediately observe the LED flash pattern. You will note the LED flashing five times, pause, and then flash two times, pause. This pattern will be repeated three times indicating the new code (52) has been accepted and stored in memory. NOTE: If after step 7, the LED flashes

ملخص المحتوى في الصفحة رقم 6

 Remote Electric Trunk Release  Remote Car Starter  Remote Window Closure  Remote Garage Door Interface NOTE: In addition there may be a second optional feature connected to your system that when the same transmitter button is pressed and released 2 times within 3 seconds (double pressed), the second optional feature will activate. This output is typically used for a remote start option and will likely prevent inadvertent activation of the remote start device if young children are playing w

ملخص المحتوى في الصفحة رقم 7

THIS PAGE LEFT BLANK INTENTIONALLY -7- 128-6628 7 of 8

ملخص المحتوى في الصفحة رقم 8

© 2003 Audiovox Electronics Corporation, Hauppauge, NY 11788 128-6628 -8- 128-6628 8 of 8