ملخص المحتوى في الصفحة رقم 1
Precautions
The lightning flash with arrowhead symbol within an equilateral triangle is
intended to alert the user to the presence of uninsulated “dangerous voltage”
within the product’s enclosure that may be of sufficient magnitude to constitute
a risk of electric shock.
The exclamation point within an equilateral triangle is intended to alert the
user to the presence of important operation and servicing instructions in the
literature accompanying the appliance.
For recycling or disposal
ملخص المحتوى في الصفحة رقم 2
Precautions WARNING: To prevent fire or shock hazard, do not expose this device to rain or moisture. Dangerous high voltage is present inside the enclosure. Do not open the cabinet. Note: If the product suddenly has no response or powers off, an electrostatic discharge may be the cause. In this circumstance, please follow the procedures below for recovery: • Unplug the unit. Wait 30 seconds. • After 30 seconds, plug the unit in and turn it on again. FCC Statement: This device complies with
ملخص المحتوى في الصفحة رقم 3
Important Safety Instructions Warnings and precautions To prevent any injuries, the following safety precautions should be observed in the installation, use, servicing and maintenance of this equipment. Before operating this equipment, please read this manual completely, and keep it nearby for future reference. Important Safety Instructions 1. Read Instructions: All the safety and operating instructions should be read before the product is operated. 2. Retain Instructions: The safety and opera
ملخص المحتوى في الصفحة رقم 4
Important Safety Instructions Antenna Safety Instructions If an outdoor antenna is connected, follow the precautions below: • An outdoor antenna should not be located in any area where it could come in contact with overhead power lines, or any other electric light or power circuits. • When installing an outdoor antenna system, extreme caution should be taken to prevent contact with power lines. Direct contact with power lines may be fatal and should be avoided at all costs. Section 810 of Nati
ملخص المحتوى في الصفحة رقم 5
Table of Contents Table Of Contents Precautions Important Safety Instructions Main Feature-----------------------------------------------------------------------------------------------------------------------------1 Package Contents-----------------------------------------------------------------------------------------------------------------2 Unit View---------------------------------------------------------------------------------------------------------------------3 Remote Control ---------
ملخص المحتوى في الصفحة رقم 6
Main Features This product incorporates the LCD display and the TV receiver in one system. Multiple Mode TV AV S-VIDEO COMPONENT DVD VGA HDMI High Quality Property High Resolution Adopt an MPEG2 decoding format to achieve horizontal resolution more than 500 lines. Superior sound Built-in Dolby Digital decoder to output high quality sound effects. Screen Support the picture size of a normal screen (4:3) and a wide screen (16:9) LCD (Liquid C
ملخص المحتوى في الصفحة رقم 7
Package Contents Please make sure the following items are included with your LCD TV/monitor. If any item is missing, contact your dealer. a. b. c. a, Main Unit b, Power Cord & RCA Cable c, Remote Control Unit 2
ملخص المحتوى في الصفحة رقم 8
Unit View 1 9 10 11 4 12 5 13 6 14 7 8 3 2 1. TFT SCREEN Present high resolution pictures 2. POWER INDICATOR The indicator lights bright blue when the TV is on, it will dim when the TV is turned off (standby mode). 9 3. REMOTE SENSOR Sense the remote control signal. 4. VOL+/- Adjust sound output level. 5. CH+/- Press to skip channels. 6. MENU 10 Display the system setup menu. 7. SOURCE Press this button to switch modes. 8. POWER 11 Press to turn on/off
ملخص المحتوى في الصفحة رقم 9
Remote Control Remote Control Drawing 21 1 1. POWER Turn the unit on or off (standby). 2. Numeric Keypad 2 Input numberic data. Access the TV channel directly. 22 3 3. Sub-channel Selector <-> This button is usually used with the numeric keypad 4 23 5 24 to tune to a channel substation (e.g., 4-1, 4-2). 6 25 26 e.g. To tune to channel 13-2, press these keys in 7 27 sequence: <1>, <3>, <–>, <2>. 8 28 4. Skip Backward Repeatedly press this button to skip backward through
ملخص المحتوى في الصفحة رقم 10
Remote Control 20. ANGEL Some discs are recorded with Multi-angle, press this button to chose the desired viewing angle. 21. OPEN/CLOSE In the DVD mode, press this button to take in/out disc automatically. 22. RETURN Reveal the previously viewed channel. 23. Skip Forward Repeatedly press this button to skip forward through DVD playback. 24. SLOW Press this button to have current playback advanced in a slow motion, repeatedly press this button to change adva
ملخص المحتوى في الصفحة رقم 11
Remote Control Remote Control Preparation • Remove the battery compartment cover located on the rear of the remote control. Insert 2 x “AAA” batteries, making sure to match their polarities (+/-) to the markings on the inside of the compartment. Replace the cover. • Batteries in the remote will last for approximately 6 months under the normal use. Replace the batteries if the remote control does not work. Do not mix old with new batteries, or different types of
ملخص المحتوى في الصفحة رقم 12
Cable Connections Antenna/Power Connection 1. Connect TV RF sources to the Coaxial TV Antenna In jack. TV RF signals include: receiving antenna/ CATV net. You can use 75 Ohm coaxial cable to connect outdoor antenna. 2. Insert one end of the supplied power cord to the player’s power jack and the other end to a 110-240V AC wall outlet. Note: Antenna requirements for good digital TV reception are more important than those for analog NTSC TV reception. For this reason, a high-quality outdoor
ملخص المحتوى في الصفحة رقم 13
Cable Connections Coaxial Output - Digital Audio Output Connector If you are using the built-in TV tuner, you may want to play the TV audio through your stereo system for better sound quality. Select TV from the Input source menu to use this connection to watch TV with digital audio sound. (If this connection is inactive, sound will be output from the built-in speakers of the TV.) A coaxial digital audio cable is required for this connection. After all necessary connections have been properly
ملخص المحتوى في الصفحة رقم 14
Cable Connections HDMI Input HDMI (High Definition Multimedia Interface) is a new type of connection that transmits digital audio and video signals simultaneously over a single cable. A HDMI cable is required for the HDMI connection.This cable has a male HDMI Type-A connector on each end, carrying both digital video and audio. These HDMI input connectors are capable of receiving video at resolutions up to 1080p (1080-progressive). After all necessary connections have been properly made, turn o
ملخص المحتوى في الصفحة رقم 15
Cable Connections S-Video Input The S-Video port is capable of accepting signals from standard video sources. (e.g., cable/satellite boxes, DVD players, VCRs, etc.) 1. Connect the S-Video port by the S-Video cable to input the video signal. S-Video cable is not included with this product 2. Connect the L, R port by the white/red plug of the supplied AV cable to input the audio signal. 3. After all necessary connections have been properly made, turn on both units, select the S-Video mode with
ملخص المحتوى في الصفحة رقم 16
TV Function Preparations 1. Connect cables.(Refer to the “Cable Connections” section for details). 2. Press the POWER button to turn on the player. 3. Select the TV signal mode, using the SOURCE button. 4. Press the CH+/- buttons to skip channels. Or you can press the number buttons to input channels directly. For an initial use, you need to scan channels under the Channesl Menu. In the Channels menu, select "Auto Channels Search", press OK to enter - - > Set the TV source as Antenna/Cable
ملخص المحتوى في الصفحة رقم 17
TV Function Audio Menu ITEM DESCRIPTION Mode Set the audio mode as Custom/Standard/Theater/ Music/News. Treble/Bass/Balance Press the left/right direction button to adjust settings. When you select an audio Mode other than "Custom", these items are automatically given parameters to correspond with the chosen preset mode, so any change to these parameters would return the Mode setting to “Custom” Digital Audio/SPDIF Set Digital Audio/SPIDIF as RAW/PC
ملخص المحتوى في الصفحة رقم 18
TV Function Settings Menu ITEM DESCRIPTION Parental You are required to enter the 4-digit password to access this Controls option. The initial password is 0000. Button Lock - This option would enable users to lock buttons on the unit panel. Block Unrated TV -The option would enable users to lock unrated TV program. USA Parental Locks - Setup the US parental control. Select this option, press OK to enter, there are TV Rating and Movie Rating, Use direct
ملخص المحتوى في الصفحة رقم 19
TV Function Settings Menu ITEM DESCRIPTION Time This option would enable users to adjust Date/Time information as well as to setup the sleep timer. Date/Time - Enter this option, set "Mode" as "Auto" / "Custom". When Mode is set as "Auto", system would adjust date/time information automatically after you select a desired Time Zone. When Mode is set as "Custom", you may customerize year/ month/day/Hour information by your own standards, using direction buttons
ملخص المحتوى في الصفحة رقم 20
AV Function The player’s AV input function would enable user to view programs from external signal sources. When input AV signals, read the user's manual of the external device as well. 1. Connect the external AV signal source. Refer to the “Cable Connection” section for details 2. Use the SOURCE button to select the relevant AV mode (AV, S-Video, Component, HDMI). System Setup Menu Various features can be preset through the setup menu, please read this section carefully. • Press MENU to displ
