Seagate ST930219A دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Setting the jumpers
Refer to the jumper settings in Figure 1 or on your drive label to configure
the drive for your system. Jumper settings can also be accessed online
from our web site at www.seagate.com.
Master or single drive: Use the options jumper block shown in Figure 1 to
Momentus 42.2 Installation Guide
configure the drive for operation. This jumper block is the 4-pin header
ST9100822A, ST9808210A, ST960821A, ST9408113A,
adjacent to pins 1 and 2 of the I/O signal pins.
ST930819A, ST9402

ملخص المحتوى في الصفحة رقم 2

Note. If these tips do not answer your question or solve the problem, con- Configuring the BIOS tact your dealer or visit http://seatools.seagate.com to download After completing the drive installation, restart your computer. Your com- puter may automatically detect your new drive. If your computer does not SeaTools™ disc diagnostics software and more troubleshooting advice. automatically detect your new drive, follow the steps below. 1. Restart your computer. While the computer restarts, run th