ملخص المحتوى في الصفحة رقم 1
User’s manual for MPEG4 DVR
Model QSNDVR9M and QSNDVR16M
*This manual is for MPEG4 QSNDVR9M 9-channel and QSNDVR16M 16-channel digital video recorder
And uses the 16-channel digital video recorder as example.
Before operation, we strongly advise that you read
ملخص المحتوى في الصفحة رقم 2
Table of Contents Digital Video Recorder (DVR) Introduction ..................................................................................................... 4 1.1 Product introduction .......................................................................................................................... 4 1.2 Features of this DVR .......................................................................................................................... 4 Installation Notice ..........
ملخص المحتوى في الصفحة رقم 3
3.2.1 SETUP-SYSTEM .................................................................................................................. 34 3.2.2 SETUP-LIVE ......................................................................................................................... 39 3.2.3 SETUP-REC ......................................................................................................................... 42 3.2.4 SETUP-STORAGE .......................................................
ملخص المحتوى في الصفحة رقم 4
Digital Video Recorder (DVR) Introduction 1.1 Product introduction This DVR is designed specially for CCTV system. It uses an embedded processor and embedded operating system working with the high-powered code and decode chip. In addition, it uses advanced IT technology to make the system more stable, such as the audio code and decode technology, large capacity hard
ملخص المحتوى في الصفحة رقم 5
Format Standard MPEG-4 compression format Storage Supports up to four IDE Hard Drives simultaneously (Or three IDE HDDs and one IDE DVD-RW/CD-RW) Backup Auto-play software automatically packed in backup files, and Auto-water-mark check in backup files to assure files’ authenticity Support backup via USB 2.0 to USB flash memory, or CDRW, DVD-RW to CD-R/DVD-R respectively Support remote backup by “Net Client” through LAN or internet Record and playback Record modes: M
ملخص المحتوى في الصفحة رقم 6
Alarm 9/16 alarm inputs and 4 alarm outputs, TTL alarm output PTZ control Supports decoder which communicates with RS485 Supports speed dome Supports PTZ through network Communication port RS 485 equipped Network Supports TCP/IP protocol Supports wide bandwidth network through modem (PPPOE) Supports static IP and dynamic IP (DHCP) Real time preview/playback/monitoring with audio signal through network Supports control PTZ camera through the netw
ملخص المحتوى في الصفحة رقم 7
Installation Notice Attention: Before connecting to other equipment, please make sure the device is powered off. Do not hot plug in! 2.1 Checking the contents Check the contents when you receive the unit, to make sure you have all the parts. Normally it will contain: a remote control, a power cable, a CD-Rom with “Net Client” software, screws for installing HDDs 2.2 Installing the Hard Drive 2.2.1 Install reminder Please confirm the size of HDDs needed and c
ملخص المحتوى في الصفحة رقم 8
2.2.2 Install tool One Phillips screwdriver 2.2.3 Install process Open the DVR using screwdriver Set one HDD as master and the other as slave if two HDDs are connected to one ATA interface!!! Attention: Hard Drives connected to the same parallel cable can not be set as master+master or slave+slave, they must be master+slave!!! HDD setup: Using a Maxtor Hard Drive (DiamondMax Plus 8 ATA/133 40GB) as example. Read the jumper diagram on the rear of HDD No jumper=DS(SLAVE)
ملخص المحتوى في الصفحة رقم 9
ملخص المحتوى في الصفحة رقم 10
Jumper area The picture blow is the IDE connection/Power connection section of the HDD. Jumper area Jumper according to the diagram above SLAVE MASTER The sequence of read/write data from HDD The ATA interface which is near the motherboard center is the secondary interface, the next ATA interface which is near the motherboard edge is the primary interface. The sketch is in the following. The H
ملخص المحتوى في الصفحة رقم 11
Primary ATA interface is HDD A, the slave is HDD B. The master HDD connected to secondary ATA interface is HDD C, the slave is HDD D. The record sequence is: HDD A→HDD B→HDD C→HDD D Overwrite sequence: The sequence is irrespective of HDD. The DVR overwrites HDD from the oldest record file when HDD is full. Motherboard Operation Put the HDD into the HDD fixation rack. If the user wants to install mo
ملخص المحتوى في الصفحة رقم 12
19 pins are in the other row). Make sure pins are plugged into interface correctly. Connect the power supply to HDD Sketch map of installation Close the device cover and lock it with screws Attention: Please format the HDD before using. If the user wants to connect the CD/DVD driver to the ATA interface, please choose the secondary interface, that is near the center of the motherboard. Furthermore, the CD/DVD driver must be set as master, and the HDD whi
ملخص المحتوى في الصفحة رقم 13
1 2 Second, attach the HDD by tw o screw s on both Fir st, put the HDD into the HDD fixation rack sides 4 3 Third, connect the HDD cable Fourth, connect the pow er supply to HDD Sketch of installation Page 15 x
ملخص المحتوى في الصفحة رقم 14
2.3 Back panel and interface terminals Attention: The real connections on the back panel might be slightly different from the sketch below. 2.3.1 Back panel of 16-channel DVR ALARM OUT CAM1 ALARM IN CAM2 CAM4 CAM7 CAM3 CAM5 CAM6 CAM8 AUDIO IN 1 AUDIO IN 2 1 2 3 4 1 2 5 7 3 4 6 8 CAM9 CAM10 CAM11 CAM 12 CAM13 CAM15 CAM16 CAM1 4 AUDIO IN 4 AUDIO IN
ملخص المحتوى في الصفحة رقم 15
1 Video input 1-16 2 Spot output 3 Video output 4 S video output 5 Audio output Page 17
ملخص المحتوى في الصفحة رقم 16
6 LAN port 7 Audio in 1-4 8 Alarm input1-16 9 Alarm output Page 18
ملخص المحتوى في الصفحة رقم 17
10 Fan vent 11 Power plug 12 USB port 13 VGA port 14 RS 232 port Null 15 RS485 port Page 19
ملخص المحتوى في الصفحة رقم 18
2.3.2 Back panel of 9-channel DVR ALARM OUT ALA RM IN AUD IO IN 1 AUDIO IN 2 CA M 1 CA M 5 CAM 7 1 2 3 4 CAM 3 CAM 9 5 1 2 3 4 6 7 8 9 CA M 4 CAM 2 CA M 6 CAM 8 AUD IO IN 3 AUDIO IN 4 VI DEO OUT S VID EO AUD IO OU T SPO T OUT GND COM + - RS- 4 85 LAN RS- 2 32 VG A USB Back panel of 9-channel DVR The difference between 9-channel and 16-channel is the 9-channel has 9 video i
ملخص المحتوى في الصفحة رقم 19
2.4 Front panel and interface terminals Attention: The actual buttons on the front panel please might be slightly difference from this sketch. 14 1 28 11 15 13 LED 2 P T 1 3 27 12 5 4 26 6 Z/F 16 23 7 8 9 AUDIO 7 0 MODE B ACKUP SEAR CH STO P REC PLAY FF REV 17 Power MENU FUNCTION INFO R USB 21 22 25 2 19 18 4 5 6 8 9 10 20 24 Number Icon Description Number Icon Description Number Ic
ملخص المحتوى في الصفحة رقم 20
7 Zoom/Focus 8 Audio on/off button control 9 Backup button 10 Menu button 11 Function button 12 Status button 13 Move Left 14 Move Up 15 Enter button 16 Move Right 17 Move down 18 Record button 19 Shuttle: to control 20 Shuttle: to control the the DVR to play playback speed the record frame by frame. 21 Search button 22 Play button
