Honeywell HNDR-S 4848 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

HONEYWELL SECURITY TECHNICAL BULLETIN 11 December 2008

Honeywell Video Systems
Subject: Control HNDR-S 4848 DVR by VideoBlox HEGS5BLX

Introduction

This document describes the Protocol Interface Translator (PIT) operation specific to the Honeywell HNDR-S
series DVR. For further details on the PIT, please refer to the PIT User manual. For further details on the DVR,
please refer to the appropriate Honeywell HNDR-S DVR manual.

Quick Start Switch Settings

Output
S

ملخص المحتوى في الصفحة رقم 2

HONEYWELL SECURITY TECHNICAL BULLETIN 11 December 2008 Hardware Configuration • Connect CPU RS422 Master Port to Slave Port of HVBPIT44. • Connect Master Port of HVBPIT44 to HNDR-S Com 2 (RS-485). CPU RS422 Master Port HVBPIT44 Slave Port Pin Number (DB9 Female) (DB9 Female) 1 Tx- Rx- 2 Tx+ Rx+ 3 Rx+ Tx+ 4 Rx- Tx- 5 Signal Gnd Signal Gnd 6 +12V source +12V input 7 NC NC 8 NC NC 9 Ground Ground HVBPIT44 Master Port Pin Number HRHD-S Com 2 (DB9 Female)

ملخص المحتوى في الصفحة رقم 3

HONEYWELL SECURITY TECHNICAL BULLETIN 11 December 2008 Device Configuration Go to Control page to configure external CCTV peripherals which may be controlled by VideoBloX keyboard. 1. Copy the HNDR-S.db and HNDR-S.mb files to root directory “C:\Program Files\Honeywell\VBloXCFG\DBF\” 2. Execute the VbloxCFG software and go to “Control” page. 3. Select the “Device Type” which is to be configured. 4. Click icon to browse “HNDR-S.db” which is locate in “C:\Program

ملخص المحتوى في الصفحة رقم 4

HONEYWELL SECURITY TECHNICAL BULLETIN 11 December 2008 HNDR-S 4848 DVR Configuration 1. Configure Communication port a. Push Menu button of DVR and enter the DVR setting menu. b. Move to System menu and select Serial Setup. c. Move to COM2 485 and select Keyboard HTX-3000 as below figure. 2. Configure Keyboard Control Address and Keyboard PTZ address as below figure. a. Push Menu button of DVR and enter the DVR setting menu. b. Move to Miscellaneous menu.

ملخص المحتوى في الصفحة رقم 5

HONEYWELL SECURITY TECHNICAL BULLETIN 11 December 2008 HEGS5BLX Operation To select “HNDR-S 4848”, press “DVR” button. Then press “1” + “Enter” buttons to select DVR number 1. Joystick IM J K L A B C D E F G H DVR Function Keys Item Function supported Description (The Keyboard should be in DVR mode for the below operation) by Keyboard 1 Menu Press “H” 2 Play Press “B” 3 Rewind Press “G” 4 Forward AUX Mode LED on, Press “C” 5 Search Press “C” 6 Sequen