Havis-Shields KK-K9-F12-K دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION INSTRUCTIONS KK-K9-F12-K
2000-2006 FORD EXCURSION

TOOLS REQUIRED:
Power Drill Ratchet Wrench With 6” Extension
Standard & Metric Socket Sets Torx Bit Set
Phillips Screw Driver 4 ½” Hole Saw (Exhaust Fan Option)
7/16” Wrench Caulk Gun
Wire Cutters / Crimping tool

HARDWARE: Some of this hardware is already attached.
QTY: DESCRIPTION: PART #:
28 ¼-20 X ½” Stainless carriage bolts GSM 32022
30 ¼-20 X ¾” Stainless carriage bolts GSM 32024
64 ¼-20 Serrated nuts GS

ملخص المحتوى في الصفحة رقم 2

2. Remove rear OEM door panels: • Remove speaker, door handle, and lock • Remove switch assembly from plastic housing (leave plug on switch) Note: if doors have electric door switches, they must be reattached to original plug assembly. Switch assembly must then be wired-tied down so it does not interfere with window or door latch operations 3. Install mounting legs: • Using ¼-20 x ¾” carriage bolts attach mounting legs to floor of vehicle using 1/4” x 1 ½” hex head lag screws.

ملخص المحتوى في الصفحة رقم 3

7. Door panels and window guards: • Center door panels so edges do not hang over. • Attach to door with #10 x ½” stainless sheet metal screws. Note: window guards have holes around perimeter for permanent mounting. These holes are not used with hinge kit! They also come flat in shipping. The guard must be pre-bent so it fits tight against the door window frame. • Hold window guard with pre-assembled hinge and upper bracket onto window frame. • Make sure guard is centered on win