ملخص المحتوى في الصفحة رقم 1
4
INSTALL INSTRUCTIONS C-VS-800-CV
VEHICLE SPECIFIC CONSOLE &
RADIO/HVAC RELOCATION HOUSING
1997-2008 FORD CROWN VICTORIA
TOOLS REQUIRED:
Ratcheting wrench Tin snips (if necessary)
Standard/Metric socket set Powered Drill w/ 5/16” drill bit
Screwdriver set
HARDWARE:
QTY DESCRIPTION PART #
2 #10 x ¾” Phillips sheet metal screws GSM33195
1 Torx Screw Kit C-HK-1
Always!
Disconnect the vehicles’ battery. Removing seat bolts on
some vehicles may give the vehicles compute
ملخص المحتوى في الصفحة رقم 2
With the tray removed, wire Unplug from the accessories. harnesses for the lighter outlet and ashtray light will need to be removed Remove the ashtray frame from the dashboard by removing the hex head screws located in the back of the frame. This is not necessary. If desired, you can cut the power point bracket out of the ashtray/power point assembly. Note: This must be removed in order for the console to slide into the ashtray slide rails. Note: The next few steps are for ap
ملخص المحتوى في الصفحة رقم 3
Note: If NOT relocating Notch AM/FM radio and/or HVAC controls, resume installation at this point Re-route HVAC controller and the It is necessary to notch the OEM AM/FM radio harness and antenna ashtray/power point frame assembly if to the VS console relocating the HVAC controls to the VS console. This will allow the HVAC vacuum hoses to reach the VS console Remove wire plug going to Drill out spot-welds that hold the Power point detached from Ashtray/Power point frame power point
ملخص المحتوى في الصفحة رقم 4
Pre-drill OEM dash using holes in Holes are for screws to attach to the View of console from inside console as a drill template OEM dash Attach using #10 x ¾” sheet metal Final installation of console screws. Install components according to specific application Install HVAC controller into C- Install AM/FM radio if necessary, as EB40-ACV-1P as shown and install shown above. into console above AM/FM radio C-VS-800-CV_INST_9-07 4
