NuTone VAC PAN CI-365 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
VacPan™ Automatic Dustpan Inlet
MODEL: CI-365
READ INSTRUCTIONS BEFORE INSTALLATION
IMPORTANT NOTES:
1 1
1. For maximum clearance under cabinets use 2 /2" X 3 /2" short 90° elbow.
2. Check for an air tight seal at VacPan™ and elbow prior to installation.
3. If required, use Teflon tape to make air tight seal but do not use glue.
4. Make certain clearance is available in kick space prior to installation under cabinets.
5. Use central

ملخص المحتوى في الصفحة رقم 2

INSTALLATION OPTION #1 - UNDER CABINET ACCESS TO PIPING FROM BELOW Refer to Figure 2 1. Select a location under cabinet for VacPan™ (6) so that new fittings can be connected to existing pipe. Drill small reference hole under location of VacPan™ to determine position in basement or crawl space. 2. Using a hole saw, cut access hole (3) in floor under cabinet. Position access hole (3) so that final fittings (7) can be installed by reaching through access hole (3). 3 3. Cut 6 /4" long slot alon

ملخص المحتوى في الصفحة رقم 3

INSTALLATION OPTION #2 - IN WALLS ALONG BASE BOARDS Refer to Figure 3 (ACCESS TO PIPING FROM BELOW) 1. Locate studs (1) in the wall at the location VacPan™ will be installed. 2. VacPan™ should be located tight to one side in stud space. 3. Drill a small reference hole (2) through the floor under area of VacPan™. This will establish location from basement. 4. From below, use hole saw to remove wood floor and wood plate at location of VacPan™ between studs in wall cavity to provide access hol

ملخص المحتوى في الصفحة رقم 4

INSTALLATION NEW HOME CONSTRUCTION Refer to Figure 5 1. Cut out wall plate (9) between two studs at the location of VacPan™. Cut a 6 3/4" piece of wall plate and refasten to floor temporary rough-in block. (10) This will act as temporary rough-in block that will force all trades to finish around providing a slot in wall for installation of VacPan™. Make certain that screws (11) remain exposed so that block can be removed in the future. 2. Flooring contractor must run flooring under block. 3