Grizzly T25449 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

MODEL T25448/T25449
DUST COLLECTOR
REMOTE SWITCH
INSTRUCTIONS
For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
Introduction
The Model T25448/T25449 Dust Collector
Remote Switch (Figure 1) allows you to remotely To ensure safe operation:
turn a dust collector ON/OFF from a distance of
• Only connect the switch box to power sup-
up to 75 feet.
ply that meets the listed specifications.
• Do not connect the switch box to a dust
Read and und

ملخص المحتوى في الصفحة رقم 2

Installation Programming Switch Box 1. Place the switch box in a dry, protected loca- You can program one switch box to operate with tion within reach of the power receptacle and several remote controllers and one remote con- the dust collector power cord. troller to operate several switch boxes. The steps to accomplish any combination of these options 2. Plug the switch box into the proper power are the same. receptacle (see Figures 2–3). before beginning, read through the entire pro- cedure

ملخص المحتوى في الصفحة رقم 3

4. Press either button on the remote controller Operation (see Figure 5)—you will hear three beeps 1. Make sure the switch box is properly installed and the red receiving light on the switch box and correctly programmed with the remote will flash three times. controller. 2. Turn the dust collector ON/OFF switch to ON. Sliding ON button Cover 3. Press the remote controller ON button once to turn the dust collector ON. The green power light on the switch box will also illumi- nate (see Figu

ملخص المحتوى في الصفحة رقم 4

Troubleshooting Review the troubleshooting and procedures in this subsection if a problem develops. If you need additional help with a procedure, call our Technical Support at (570) 546-9663. Note: Please gather the serial number and manufacture date of your switch before calling. Symptom Possible Cause Possible Solution Switch box will not 1. Switch box not connected to power. 1. Connect switch box to correct power source (Page 2). turn ON. 2. Remote controller not properly programmed 2. Prope