SECO-LARM USA Enforcer E-942FC-600SQ دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Magnetic Gate Lock Bracket Installation Manual
Magnetic Gate Lock Bracket Installation Manual
TROUBLESHOOTING
Installation Manual
Problem: Possible cause: Solutions:
®
Gate does not lock No power • Check to make sure the wires are secure
ENFORCER
• Check that the power supply is connected
and operating
• Make sure the unit is wired correctly
E-942FC-1K3SQ
Gate locks, but can be Poor contact between • Make sure the electromagnet and armature
easily forced open electromagnet and plate are properly

ملخص المحتوى في الصفحة رقم 2

Magnetic Gate Lock Bracket Installation Manual Magnetic Gate Lock Bracket Installation Manual C. Mount the armature — Mounting Diagram: 1. Once the electromagnet is mounted, determine the armature bracket location and tack weld into place. (Tack weld only.) 2. Dismount the armature plate from the bracket. Warning: Failure to remove the armature plate from the bracket will damage the armature and rubber washer. Weld the armature bracket with 3 or 4 beads about 1” apart. Make sure not to weld near