NuTone LA-107 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
Viking Door Chime
INSTALLING THE WIRING
MODEL: LA-107 SERIES
1. Use standard bell/chime wire (20 gauge, two-conductor).
2. Run wires as shown in Figure 2 for installation using transformer.
• For use with either a transformer or batteries
3. Run wires as shown in Figure 3 for installation using batteries.
LOCATION
MOUNTING CHIME BASE
TRANSFORMER: Mount a 10 or 16-volt transformer to a
Refer to Figure 4.
conveniently located junction box.

ملخص المحتوى في الصفحة رقم 2

WIRING CONNECTIONS REPLACEMENT INSTALLATION 1. Use wire nuts to make connections. Insulate all connections with 1. Turn off house power until installation is complete. electrical tape. 2. Remove cover from existing chime and disconnect wires from 2. INSTALLATION USING TRANSFORMER. terminal screws. Label all wires (Front, Transformer, Rear) as you Refer to Figure 2. Connect pushbutton and transformer wires to remove them. NOTE: Any additional wires (for example: common terminal screws marked Fron