Ives Top Center Pivot 7253 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Installation Instructions
7253
Bottom Center Pivot
Door leaf
Base plate screw
Base plate
Anchor pin
1. Prepare and mortise bottom of door and floor to receive pivot set. Determine pivot location
using dimensions on reverse side. Depth of mortise in bottom of door will determine clearance.
Be sure to properly locate and mark pivot center point of the base plate.
2. Locate, drill, and tap 1/4-20 mounting holes for metal door. Locate and drill pilot holes for
#14 wood screws for wood door. Mount d

ملخص المحتوى في الصفحة رقم 2

NOTE ! It is very important for installer to verify that center line of top pivot point lines up with center line of bottom pivot point before final installation. Door Leaf Radius of heel edge of door must not exceed pivot point to C pivot and door jamb distance L 1-3/4” 44 mm* 5/8” 1-3/16” to 16 mm 30 mm 1/8” 3 mm Pivot center may be * varied as needed. The minimum distance is 1-3/4” 1-3/4” as shown. 44 mm* C pivot L and door Pivot Base 16002-00 16002 Rev. 4