ملخص المحتوى في الصفحة رقم 1
auJTMM
rëÉêÛë=dìáÇÉ
• Manual #: 26-0601000-00
• Revision: 02
ملخص المحتوى في الصفحة رقم 2
auJTMM= √=rëÉêÛë=dìáÇÉ `çéóêáÖÜí © Barco. May 19, 2010 All rights reserved. No part of this document may be copied, reproduced or translated. It shall not otherwise be recorded, transmitted or stored in a retrieval system without the prior written consent of Barco. kçíáÅÉ Barco provides this manual “as is” without warranty of any kind, either expressed or implied, including but not limited to the implied warranties or merchantability and fitness for a particular purpose. Barco may make imp
ملخص المحتوى في الصفحة رقم 3
agreed upon in the contract, all guarantee claims of the purchaser will be rendered invalid. Not included in the guarantee coverage are system failures which are attributed to programs or special electronic circuitry provided by the purchaser, e.g. interfaces. Normal wear as well as normal maintenance are not subject to the guarantee provided by Barco either. The environmental conditions as well as the servicing and maintenance regulations specified in this manual must be complied with by t
ملخص المحتوى في الصفحة رقم 4
léÉê~íçêë=p~ÑÉíó=pìãã~êó The general safety information in this summary is for operating personnel. aç=kçí=oÉãçîÉ=`çîÉêë=çê=m~åÉäë There are no user-serviceable parts within the unit. Removal of the top cover will expose dangerous voltages. To avoid personal injury, do not remove the top cover. Do not operate the unit without the cover installed. mçïÉê=pçìêÅÉ This product is intended to operate from a power source that will not apply more than 230 volts rms between the supply conductors o
ملخص المحتوى في الصفحة رقم 5
qÉêãë=få=qÜáë=j~åì~ä=~åÇ=bèìáéãÉåí=j~êâáåÖ= t^okfkd Highlights an operating procedure, practice, condition, statement, etc., which, if not strictly observed, could result in injury to or death of personnel. Highlights an essential operating procedure, condition or Note statement. `^rqflk The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance
ملخص المحتوى في الصفحة رقم 6
`Ü~åÖÉ=eáëíçêó The table below lists the changes to the DX-700 User’s Guide. Table 0-1. Change History Rev Date ECP # Description Approved By A 6/14/07 (ECO) 1846 DX-700 User’s Guide Kent Vogel 02 5/19/10 578655 DX-700 User’s Guide Revisions: Kent Vogel • Addition of Genlock options • Addition of the Expert Menu • Implementation of stacking • Implementation of output grouping • Implementation of new delay features • Revision of all menu trees 6 DX-700 • User’s Guide • Rev 02
ملخص المحتوى في الصفحة رقم 7
q~ÄäÉ=çÑ=`çåíÉåíë `Ü~éíÉê=N fåíêçÇìÅíáçå=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=NP In This Chapter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Firmware Version . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Chapter Structure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 How to Use This Guide. . . . . . .
ملخص المحتوى في الصفحة رقم 8
Table of Contents Touch Screen Conventions . . . . . . . . . . . . . . . . . . . . . . . . . . 36 Test Patterns . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38 DX-700 Rear Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 Input Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 41 Input Module Block Diagram . . . . . . . . . . . . . . . . . . . . . . . . . 41 Inpu
ملخص المحتوى في الصفحة رقم 9
Table of Contents Recall a Preset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 104 Rename a Preset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 105 Delete a Preset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 106 Delete All Presets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 106 Using the Input Management Menu . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 107 Input Management Menu Tree . . . . .
ملخص المحتوى في الصفحة رقم 10
Table of Contents `Ü~éíÉê=R réÖê~ÇáåÖ=cáêãï~êÉ=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=KNST In This Chapter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 167 Firmware Upgrade Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 168 Hardware Requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 168 Computer and Download Requirements . . . . . . . . . . . . . . .
ملخص المحتوى في الصفحة رقم 11
Table of Contents Output Fiberlink Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 194 FIBERRXPWR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 194 FIBERKEYREF . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 195 FIBERFILTER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 195 FIBERSN. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 196 FIBERPCB . . . . . . . . . . . . . . . . . . . .
ملخص المحتوى في الصفحة رقم 12
Table of Contents fåÇÉñ =K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=KONV 12 DX-700 • User’s Guide • Rev 02
ملخص المحتوى في الصفحة رقم 13
NK==fåíêçÇìÅíáçå få=qÜáë=`Ü~éíÉê This chapter is designed to introduce you to the DX-700 User’s Guide. Areas to be covered are: • Firmware Version • Chapter Structure • How to Use This Guide • Conventions • About the DX-700 • Connectivity Diagrams • Application Questions DX-700 • User’s Guide • Rev 02 13
ملخص المحتوى في الصفحة رقم 14
NK==fåíêçÇìÅíáçå Firmware Version cáêãï~êÉ=sÉêëáçå This version of the DX-700 User’s Guide is based on firmware version 2.30. `Ü~éíÉê=píêìÅíìêÉ The following chapters provide instructions for all aspects of DX-700 operations: • Chapter 1, “Introduction” provides a system overview, a list of features, and a system connectivity diagram. • Chapter 2, “Hardware Orientation” on page 33 provides detailed diagrams of the DX-700’s front and rear panels. • Chapter 3, “Installation” on page 61 pro
ملخص المحتوى في الصفحة رقم 15
NK==fåíêçÇìÅíáçå How to Use This Guide eçï=íç=rëÉ=qÜáë=dìáÇÉ This section provides important tips for streamlining the use of this User’s Guide in its electronic PDF form. k~îáÖ~íáåÖ Use Acrobat Reader’s “bookmarks” to navigate to the desired location. All chapter files have the same bookmark structure for instant navigation to any section. Please note: • Extensive hyperlinks are provided within the chapters. • Use Acrobat’s “Go to Previous View” and “Return to Next View” buttons to trace
ملخص المحتوى في الصفحة رقم 16
NK==fåíêçÇìÅíáçå About the DX-700 ^Äçìí=íÜÉ=auJTMM The following topics are discussed in this section: • Overview • Basic Features • New Features • Theory of Operation • Understanding Banks • Grouping Outputs • DX-700 Stacking • DX-700 Scaling • DX-700 Video Processing Delay • DX-700 Input Identification • DX-700 Input Switching • Firmware Upgrades • Application Questions lîÉêîáÉï The DX-700 is a multi-window video processor designed as a versatile front-end to all Barco LED products. • Curre
ملخص المحتوى في الصفحة رقم 17
NK==fåíêçÇìÅíáçå About the DX-700 _~ëáÅ=cÉ~íìêÉë Basic features of the DX-700=system are listed below: • System Features ~ Basic configuration is performed using front panel controls on the DX- 700. Advanced configuration is performed using Director Toolset. ~ Seven rear panel slots are provided for input and output modules. All modules are fully shielded and field-installable. ~ Input and output modules can be configured into “banks” of functionality — essentially, independent video proces
ملخص المحتوى في الصفحة رقم 18
NK==fåíêçÇìÅíáçå About the DX-700 kÉï=cÉ~íìêÉë The following topics are discussed in this section: • Firmware Version 2.10 Features • Firmware Version 2.30 Features cáêãï~êÉ=sÉêëáçå=OKNM=cÉ~íìêÉë The following features and functions were implemented in firmware version 2.10: • External Stacking — This mode enables multiple DX-700 units to be joined together to increase the overall canvas size, either horizontally or vertically. For xternal Stacking” section on page 26. details, refer to the
ملخص المحتوى في الصفحة رقم 19
NK==fåíêçÇìÅíáçå About the DX-700 • Output Timing — Controls for output timing have been added to the Expert Menu. In Chapter 4, refer to the “Using the Expert Menu” section on page 158. • A Minimum Delay Mode has been added. Refer to the “DX-700 Video Processing Delay” section on page 28 for details. • Restore Scaling — In the Output Display Menu, buttons have been added to allow users to reset tile H/V scaling parameters. In Chapter 4, refer to the “Display Management Operations” sect
ملخص المحتوى في الصفحة رقم 20
NK==fåíêçÇìÅíáçå About the DX-700 qÜÉçêó=çÑ=léÉê~íáçå The following topics are discussed in this section: • Introduction to the Canvas • Introduction to the Wizards • Sample DVI Output Module Configurations • Sample NNI Output Module Configurations fåíêçÇìÅíáçå=íç=íÜÉ=`~åî~ë The DX-700 processor enables you to set up video walls, and define input sources and LED outputs with precision. The DX-700's input and output modules are configured into "banks," consisting of one or more input modules,
