American DJ PROFORMER SERIES XDM-352 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

User Instructions
X D M - 3 5 2
PREAMP MIXER
Thank you for purchasing this American DJ® product. The XDM-352 is ready to be used,
there is no assembly required. Please read the following instructions before installing
or using your new unit. The XDM-352 has a 2 year limited warranty!
C A U T I O N ! - Keep this device away from rain and moisture!
Safety Instructions
Always plug in the power last. Make sure that the Power switch is set to the OFF position before connecting other devices
to the

ملخص المحتوى في الصفحة رقم 2

Operating Determinations When installing this mixer, please make sure that the device is not exposed to extreme heat, moisture or dust! There should not be any cables lying around. Doing so endangers you as well as others. Do not operate the mixer in extremely hot (more than 30˚C / 100˚F) or extremely cold (less than 5˚C / 40˚F) surroundings. Keep away from direct sunlight and heaters. Operate the mixer only after becoming familiar with its functions. Do not permit operation by persons not quali

ملخص المحتوى في الصفحة رقم 3

Functions 20 4 3 2 14 15 16 17 24 1 21 18 22 23 19 5 8 9 10 11 12 13 6 7 (1) POWER SWITCH (2) BASS/TREBLE CONTROL - Used to increase or decrease the LOWs and HIs of the input signal. (3) LINE/PHONO SWITCH - Used to select the input to be sent to the individual channel. Channel 1 and 2 can be switched phono/line. Channel 3 can either be switched line/line or phono/line. The selector is on the rear panel. Channel 4 can be switched Mic2/line. (4) CHANNEL FADER - Used to adjust the output level of

ملخص المحتوى في الصفحة رقم 4

Functions (Cont.) (14) MASTER LEVEL-DISPLAY - The display shows the signal level of the master output on the left and right jack. (15) BALANCE CONTROL - Used to adjust how much of the signal is sent to the left and right MASTER OUT jack (31). (16) STEREO/MONO SWITCH - Used to set the master output to mono or stereo. If this switch is set to STEREO, the master signal is sent to the MASTER OUT jacks (31). For mono and bridged operation, set this switch to MONO and connect your amplifier with the

ملخص المحتوى في الصفحة رقم 5

Inputs and Outputs (Cont.) (35) AC CONNECTION - AC power cord. (36) FUSE - Fuseholder. Only replace the fuse when the device is disconnected from mains. Only replace by fuses of the same power and rating. (37) AC VOLTAGE SELECTOR - Make sure that the selector is properly set. Replacing the Crossfader Instructions for replacing the crossfader: • Disconnect from main power supply. • Remove the fader knob. • Remove the two outer screws. • Take the fader out and unplug the connecti