ملخص المحتوى في الصفحة رقم 1
1930c Owner's Manual
900MHz Digital Cordless Phone
with Call Waiting Caller ID
Sprint National HelpDesk
1 800 949-4357
ملخص المحتوى في الصفحة رقم 2
TABLE OF CONTENTS Page INTRODUCTION ............................................................................................................. 1 Special Features ............................................................................................................. 2 Parts Check List .............................................................................................................. 3 FCC AND IC REGULATIONS ...............................................................
ملخص المحتوى في الصفحة رقم 3
ملخص المحتوى في الصفحة رقم 4
INTRODUCTION Special Features ¥ Easy answer - When the phone ¥ 900 MHz Operation. rings, simply press any key other than OFF, MUTE, or the Volume ¥ Fully Digital Link between Handset Keys on the handset to answer. and Base . ¥ Digitally-Scrambled Voice Commu- ¥ Auto hang up when returning the nication. handset to the base cradle. ¥ Alphanumeric Call Waiting Caller ¥ Extension in use indicator. ¥ Message waiting indicator for use ID. with voicemail service. ¥ 2 row by 12 character 5x7 dot matrix
ملخص المحتوى في الصفحة رقم 5
a w p o t m t b jk g x u q p o ABC TUV DEF oper WXYZ PQRS MNO INTRODUCTION Parts Check List To purchase replacement battery 1. Handset packs, call VTECH Communications 2. Base Unit at 1-800-595-9511. In Canada, call 3. Wall mounting bracket VTECH Electronics at 1-800-267- 4. AC power adapter 7377. 5. Belt clip 6. Battery pack 7. Telephone line cord VT 1930c 1 2 3 4 5 6 7 8 9 FLASH PAUSE PHONE OFF HOLD # 0 * 1 2 3 SPARE BATT CHARGING HS IN-USE POWER 5 6 4 MEM Q.MEM REDIAL 9 7 8 HOLD FLAS
ملخص المحتوى في الصفحة رقم 6
FCC and IC Regulations This equipment complies with Parts 15 and 68 of the Federal Communications FCC Part 15 Commission (FCC) rules for the United Warning: Changes or modifications to States. It also complies with regula- this unit not expressly approved by the tions RSS210 and CS-03 of Industry party responsible for compliances could and Science Canada. Operation is void the userÕs authority to operate subject to the following two conditions: the equipment. (1) this device may not cause int
ملخص المحتوى في الصفحة رقم 7
FCC and IC Regulations This equipment may not be used on FCC Part 68 coin service provided by the phone The FCC requires that you connect company or Party Lines. your cordless telephone to the nation- wide telephone network through a The REN is useful in determining the modular telephone jack (USOC RJ11C, number of devices you may connect RJ11W or RJ14). to your telephone line and still enable the devices to ring when you receive Your telephone company may discon- a call. The general rule is th
ملخص المحتوى في الصفحة رقم 8
FCC and IC Regulations Before installing this equipment, users Caution: Users should not attempt to should ensure that it is permissible to make such connections be connected to the facilities of the themselves, but should local telecommunications company. contact the appropriate The equipment must also be installed electrical inspection using an acceptable method of authority, or electrician, as connection. The customer should be appropriate. aware that compliance with the above conditions may
ملخص المحتوى في الصفحة رقم 9
IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, 7. This product should be operated basic safety precautions should always only from the type of power source be followed to reduce the risk of fire, indicated on the marking label. If electric shock and injury to persons, you are not sure of the type of including the following: power supply to your home, consult your dealer or local power company. 1.Read and understand all instructions. 8. Do not allow anything to rest on the po
ملخص المحتوى في الصفحة رقم 10
IMPORTANT SAFETY INSTRUCTIONS 12.Unplug this product from the wall E. If the product has been dropped outlet and refer servicing to a and the cabinet has been VTech authorized service facility damaged. under the following conditions: F. If the product exhibits a distinct A. When the power supply cord or change in performance. plug is damaged or frayed. B. If liquid has been spilled into 13.Avoid using a telephone (other the product. than a cordless type) during an electrical storm. There ma
ملخص المحتوى في الصفحة رقم 11
REPLACING THE BATTERY PACK Alternatively, if you have purchased a Charging The Handset Battery Pack spare battery pack and it has been The handset of your VTech VT 1930c charging in the base unit, simply cordless telephone is powered by a rechargeable battery pack. It charges exchange the drained handset battery pack with the fully charged replace- automatically whenever the handset is ment battery pack from the base in the base. You should charge the charger. Place the drained handset batter
ملخص المحتوى في الصفحة رقم 12
ملخص المحتوى في الصفحة رقم 13
ملخص المحتوى في الصفحة رقم 14
PQRS GETTING STARTED Setting Up Your VTech VT 1930 c Choose an area near an electrical outlet and a telephone wall jack. AC Power Adapter Plug the AC power adapter into an PULSE electrical outlet and the DC connecter TONE PULSE TONE SWITCH to the back of the base unit. ON BASE RINGER OFF RINGER ON/OFF SWITCH TELEPHONE WALL JACK AC OUTLET Charge the handset battery pack before use. The battery pack recharges 9V DC TEL. LINE automatically whenever the handset is in the base unit. The batteries m
ملخص المحتوى في الصفحة رقم 15
PQRS GETTING STARTED Check for a dial tone. After the battery pack is charged, rotate the Base Unit antenna to an upright position. Pick up the Handset and press PHONE "HANDSET ON" will appear on the display, and you will hear a dial tone. If not, see ÔIN CASE OF DIFFICULTYÕ. Fill in the telephone number card on the base unit. VT 1930c 1 4 7 * HS POWER FILL IN THE MEM TELEPHONE NUMBER CARD HOLD INT.COM DIGITAL CORDLESS 9 CAUTION: 1. Never install telephone wiring during a lightning storm. 2. Ne
ملخص المحتوى في الصفحة رقم 16
TUV WXYZ oper PQRS WALL MOUNTING The Wall Mounting bracket is de- located on the back of the Base signed to fit on standard Wall Mounting Unit . plates. 1. Choose a spot near an electrical outlet and a telephone jack. Your phone requires a modular telephone jack and a standard PULSE TONE electrical outlet (120v AC). The ON OFF RINGER power cord is six feet long; make sure there is an electrical outlet within reach of the base. The outlet should not be controlled by a wall switch. If the switch i
ملخص المحتوى في الصفحة رقم 17
EXAMPLES OF THE HANDSET DISPLAY Handset Display Messages This message is displayed when the base/handset is on hold. PHONE ON is displayed when the phone is in use. This message is displayed when the live telephone line is not connected to the base unit. After pressing a volume key, this displays the current volume setting. This message is displayed when the handset microphone has been muted. This display warns of a low battery condition. The handset typically operates for at least 5 minutes af
ملخص المحتوى في الصفحة رقم 18
THE LCD DISPLAY-EXAMPLES This display is confirms that a commu- nication link has been established with the Base. This message is displayed while in OFF mode, if another phone is currently using the same line. This message is displayed when both the handset and base unit are on a call together. This display warns when an AC power failure has occurred and power is being supplied by an optional spare battery pack. 16
ملخص المحتوى في الصفحة رقم 19
BASE UNIT FUNCTION KEYS Speakerphone Key HOLD Key Press this key to either initiate or Press this key to place your answer a call from the Base Unit Speakerphone call on hold. Press Speaker. Press it again to terminate either HOLD or SPEAKER PHONE your call. to return to the call. Volume Key With a Speakerphone call on HOLD, Press the appropriate key to raise or picking up an extension phone, or lower the Speakerphone volume level. activating the VT 1930c Handset will Holding down the key w
ملخص المحتوى في الصفحة رقم 20
a m w t p o t b jk g x u q p o THE HANDSET LAYOUT ANTENNA VOLUME UP & DOWN BATTERY COMPARTMENT DISPLAY HOLD FLASH PAUSE PHONE OFF OFF KEY HOLD PHONE KEY 1 2 3 4 5 6 DIALING KEYS (0-9) 7 8 9 TONE (Temporary Tone) 0 # REDIAL * CALLER ID (CID) MEM/PGM CID REDIAL INT.COM CLR/DEL MUTE MUTE CLEAR/DELETE (CLR/DEL) KEY INTERCOM (INT.COM) KEY MEMORY/PROGRAM (MEM/PGM) KEY CHARGING CONTACTS 18 h l n r v y n e c i o s z e r
