ملخص المحتوى في الصفحة رقم 3
PLAY/STOP CLOCK CHARGING MEMO/REWIND FAST FWD SAVE HANDSET IN USE a a a aaaaaaaaaaa aaaa aaaaaaaaa INST ALLA TION Base Antenna (extended) Cover Turn system on or off. Lift panel door to access features Record or (see figure at right). play outgoing announcement. Audible clock; also use with CHANGE to set time/day. Use with other buttons to Adjust message playback volume. change settings. Fast forward during message Play messages or playback. stop message playback. Save messages. should be on ste
ملخص المحتوى في الصفحة رقم 4
aaaaaaaaaaaaaa aaaaa a a a aaaaaaaaaaaaaaaa BA TTERIES CAUTION: To reduce the risk of Charging the Replacing the Handset fire or injury to persons or Handset Battery Pack Battery Pack damage to the telephone, read and The batteries need charging when: 1 Remove the battery case cover on follow these instructions carefully. • The phone beeps four times when you the handset by pressing on the • Use Replacement Battery 4051 in the press P. indentation and sliding the cover handset. • The LOW
ملخص المحتوى في الصفحة رقم 5
aaaa aaaaa aaaaaaaa a IN CASE OF DIFFICULTY If you have difficulty operating this phone, • Place the handset in the base, • Make sure the base antenna is upright. try the suggestions below. If you still and check to make sure the • Disconnect the base from the tele- have trouble, call 1 800 722–9125. CHARGING light is on. phone jack and plug in a corded Unplug the AC adapter from the telephone. If you still hear noise or If the phone does not work at all, check outlet, wait 15 seconds, then pl
ملخص المحتوى في الصفحة رقم 6
aaaaaaaaa a aaaaaaaa IN CASE OF DIFFICULTY If you have difficulty hearing messages • Try sliding the Volume control on the If the system does not respond to remote • If messages are garbled, the recording side of the base upward to increase commands heads may be soiled and should be volume. • Make sure you are calling from a cleaned. touch tone telephone. If you hear • Unplug the system from the If the recording tape sticks or malfunctions clicks when you dial, the phone is not electrical outl
ملخص المحتوى في الصفحة رقم 7
aaaaaaaaaaaaa aaaaa aaaaaaaaaaa aaaaaaa OPERA TION to the base for recharging. You can still use Making A Call the handset to make a call or to answer a call 1 Press P, and wait for the if you hear an extension phone ringing. PHONE light to go on steadily. 2 When you hear a dial tone, dial the When the Ringer ON/OFF switch is set to number. ON, the handset stays ready to use for up to 14 days in standby mode. NOTE: You might experience a slight delay before you hear a dial tone, as the Handset
ملخص المحتوى في الصفحة رقم 8
aaaaaaaaaaaaaaa aaaaaaaa aaaaaaaaaaaaaaaaaaa aaaa MEMOR Y This cordless phone can store 10 telephone NOTE: Each pause you store is counted as numbers that you can dial just by pressing a digit. You can store up to 16 digits in each p and one of the number buttons. memory location. Additionally, the phone offers a memory For example, to store 9, PAUSE, location accessed by pressing m. 555-1234 in memory location 3: Press p, 9, (hold the 9 Storing Speed-Dial Numbers for 2 seconds, until a second
ملخص المحتوى في الصفحة رقم 9
aaaaaaa a a a a aaaa OPERA TING RANGE This cordless telephone operates at the If you move out of range during a Changing Channels maximum power allowed by the Federal phone conversation, you will hear noise or This cordless telephone has an advanced Communications Commission (FCC). interference. To improve reception, move AutoSelect feature that minimizes the Even so, the handset and base can closer to the base. chance of interference. Every time you communicate over only a certain distance an
ملخص المحتوى في الصفحة رقم 10
PLAY/STOP CLOCK CHARGING MEMO/REWIND FAST FWD SAVE HANDSET IN USE aa a aaa ANSWERING SYSTEM OPERATION Light goes on when handset is in use or battery is charging. Fast forward during message playback. Audible clock; also use with CHANGE (under the cover) to set time/day. Blinking light indicates messages are waiting. Play messages or stop Record a memo, or message playback. rewind tape during message playback. Save Adjust message playback volume. messages. 2 Press and release g, located Volume
ملخص المحتوى في الصفحة رقم 11
aa a aaa ANSWERING SYSTEM OPERATION Ring Select Listening to Your Messages Recording a Memo Use the Ring Select switch on the back side Before listening to your messages, set the You can record a memo to be stored as an of the base unit to select how many times message volume control so you can hear incoming message. The memo will be the line will ring before the system answers the messages. When you press P played back with other messages. 1 Hold down M. After a call. Set to 4 for four ring
ملخص المحتوى في الصفحة رقم 12
aa a aaa ANSWERING SYSTEM OPERATION 3 After the two beeps, wait 4 FROM A REMOTE Recording a New seconds, and the system plays TOUCH TONE PHONE Announcement back messages 1 Press 7, * after the two beeps. — OR — You will hear a series of short Press and release 1 to play Remote Access Code beeps, then one long beep. all of your messages (if there The Remote Access Code is a 3-digit code 2 After the long beep, record your are no messages, the system which lets you access your answering new announc
ملخص المحتوى في الصفحة رقم 13
2 Answering System 7610 Operation From a Remote Touch Tone Phone To access your answering system: 1 Dial your telephone number. 2 When the system answers, enter your 3-digit Remote Access Code. The system announces the number of messages received, then beeps twice and is ready to accept a command. See the other side of this card for a complete list of remote commands. © 1998 Philips Consumer Communications, L.P. All rights reserved. Printed in Mexico. 848233052 Issue 1ATT 2 Answering System
ملخص المحتوى في الصفحة رقم 14
COMMAND PRESS Play all messages 1 2 Play only new messages 1 Replay messages after playing messages Rewind Hold down 4 ; release to play. 6 Fast Forward Hold down ; release to play. 3 3 Clear messages , . Stop 5 ; press 1 to play. 7 Record announcement , , speak after long beep, 5 press to stop. Change Remote Access Code 9 , 9 , enter new code. 0 Turn system on 8 8 Turn system off , COMMAND PRESS Play all messages 1 Play only new messages 2 Replay messages 1 after playing messages R
ملخص المحتوى في الصفحة رقم 1
PLAY/STOP
CLOCK
CHARGING
MEMO/REWIND FAST FWD SAVE
HANDSET IN USE
2
User's Manual
for Cordless
Answering System
Telephone 7610
Fold open this manual for information about this
telephone's installation and operation. Please
read Part 1 – Important Product Information,
included in this package
Part 2
© 1998 Philips Consumer Communications L.P. All rights reserved.
Printed in Mexico. 848233037 Issue 1AT&T
VOLUME
ملخص المحتوى في الصفحة رقم 2
aaaaaaaaa aaaaa aaaaa aaaaaaaa INST ALLA TION Standard AC Outlet Modular Wall Jack AC Adapter Telephone Line Cord Power Cord 1 Insert the microcassette. 4 Set the Handset Ringer ON/OFF Plug the other end of the line cord Lift the cover and insert the switch. into a modular phone jack. Make microcassette with the full reel Set the switch on the side of the sure the plug snaps firmly in place. to the right. handset to ON so the handset will ring. When this switch is set to OFF 6 Mount the base
