ملخص المحتوى في الصفحة رقم 1
*--, .
. - . -. - .
DIGITAL 9OOMHZ
CORDLESS PHONE
VT 1900
MODEL VT 1900
@za
VTECH COMMUNICATIONS LTD.
Is a trademark of VTECH COMMUNICATIONS LTD.., a member
of THE VTECH GROUP OF COMPANIES.
Distributed in the U.S.A. by VTECH Communications, 8770 SW Nimbus Avenue /
Beaverton, Oregon, 97008.
Distributed in Canada by VTECH Electronics Canada Ltd., Suite 200 - 7671 Alderbridge
Way Richmond, B.C. V6X 1Z9.
Copyright 1996 for VTECH COMMUNICATIONS LTD..
91 -4032-10-00
ISSUE 0
ملخص المحتوى في الصفحة رقم 2
Page INTRODUCTION ............................................................................................................. 1 SPECIAL FEATURES ...................................................................................................... 2 PARTS CHECK LIST ....................................................................................................... 3 THE HANDSET LAYOUT ................................................................................................. 4 T
ملخص المحتوى في الصفحة رقم 3
The VTech VT1900 uses special SPECIAL FEATURES Auto hang up when returning the Congratulations! You have purchased memory in both the base and handset 900 MHz Operation handset to the base cradle one of the most sophisticated cordless which is not susceptible to power Fully Digital Link between Handset Extension in .use indicator telephones on the market! The VTech failures. This provides permanent and Base with ADPCM voice coding 24 Bit Digital Security Code for VT1900 has been designed
ملخص المحتوى في الصفحة رقم 4
Parts Check List To purchase replacement battery 1. Base unit, Handset and AC adapter packs, call VTECH Communications at HANDSET UNlT CONTROLS AND FUNCTIONS 2. One-Line Telephone Cord 1-800-624-5688. In Canada, call 3. Battery Pack VTECH Electronics at 1-800-267- 7377. 4. Mounting screws for wall mounting 5. Wall mount accessory ANTENNA VOLUME UP & DOWN \ LOW BAlTERYiMUTE INDICATOR PHONE INDICATOR \ HOLD KEY OFF KEY PHONE KEY WALL MOUNTING BRACKET u DIALING KEYS (0-9) BATER
ملخص المحتوى في الصفحة رقم 5
This equipment complies with Parts 15 FCC Part 15 and 68ofthe ~ederal Communications Warning: Changes or modifications to BASE UNIT CONTROLS AND FUNCTIONS Commission (FCC) rules for the United this unit not expressly approved by the States. lt alsocomplies with regulations party responsible for compliances could RSS210 and CS-03 of Industry and void the user's authority to operate the Science Canada. Operation is subject equipment. to the following two conditions: (1) this device may no
ملخص المحتوى في الصفحة رقم 6
FCC Part 68 This equipment may not be used on Before installing this equipment, users Your VTech VT1900 is designed to coin service provided by the phone The FCC requires that you connect should ensure that it is permissible to operate at the maximum power allowed your cordless telephone to the company or Party Lines. be connected to the facilities of the by the FCC and IC. This means your nationwide telephone network through local telecommunications company. handset and base unit can a
ملخص المحتوى في الصفحة رقم 7
12. Unplug this product from the wall CAUTION: TO REDUCE THE RISK When using your telephone 7. This product should be operated outlet and refer servicing to OF FIRE OR INJURY TO PERSONS equipment, basic safety precautions only from the type of power source qualified service personnel under BY BATTERY, READ AND FOLLOW shouldalways be followed to reduce indicated on the marking label. If the following condition: THESE INSTRUCTIONS. the risk of fire, electric shock and you are not sure of t
ملخص المحتوى في الصفحة رقم 8
Follow the steps below: 5. If the new battery pack is not SElTlNG UP YOUR VTECH VT1900 I I 1. Remove the battery case cover by already charged, place the handset 1. Choose an area near an electrical in the cradle of the base unit to pressing on the ridged lines and outlet and a telephone wall jack. slidina downward. allow it to charge for 8 hours. 3 w 2. Connect your telephone Line Cord. To Reduce the Risk of Fire or Injury AC POWER ADAPTER to Persons, Read and Follow the PRESS and Pl
ملخص المحتوى في الصفحة رقم 9
WALL INSTALLATION USING Fill in the telephone number card on MOUNTING SCREWS PROVIDED the base unit. Tools You Will Need: A hammer, a nail, a pencil or ballpoint pen, a Phillips head (+) screwdriver, and the Wall Mounting Template included in the CARD back of this booklet. 1. Choose a spot near an electrical outlet and a telephone jack. Your phone requires a modular telephone jack and a standard electrical outlet (120v AC). The power cord is six feet long; make sure there is an e
ملخص المحتوى في الصفحة رقم 10
USING THE WALL MOUNT Here's a brief guide to the features and HANG1 ADAPTOR functions of your VTech VT1900 Press OFF on the handset or place the 1. Position the wall mount bracket cordless telephone: handset in the base cradle to hang up on the base. a call. Line up the tabs on the wall mount SET-UP adaptor with the holes on the Connect telephone line cord to bottom of the base (Figure 1). base unit and telephone jack. TO PLACE A CALL ON HOLD i Press (HOLD) on the handset to Snap th
ملخص المحتوى في الصفحة رقم 11
MEMORY STORING QUICK MEMORY DIALING MAKING CALLS FLASH The phone should be m. You can use your VTech VT1900 You can make calls directly from the press (PTG) . handset whether you are at the base cordless phone with services such as Enter the two digit memory location The phone number stored in Call Waiting. Instead of pressing the or away from it. (00 .. 20). memory location 00 will be switch-hook (as you would on a regular Enter the number you wish to automatically dialed after a
ملخص المحتوى في الصفحة رقم 12
TEMPORARY TONE PROGRAMMING THE RINGER TURNING OFF THE RINGER To turn off the ringer do the following: If you have a rotary (dial-pulse) The handset ringer is capable of four different types of ringer tones for each telephone service, (TONEIPULSE Press Press the 0 # key. switch is set to PULSE), this feature line. The following section details how to select different ringer types and how allows you to enter special codes and tones to operate answering machines, to turn off the handset ri
ملخص المحتوى في الصفحة رقم 13
The VTech VT1900 is capable of QUICK MEMORY DIALING STORING NUMBERS USING REDIAL Enter the memory location you memory dialing. You can dial by The QUI. MEM key gives you one To store the last number dialed into a wish to store the number in. pressing the memory location in which button access to the speed dial number permanent memory location, do the Press =L). the number was stored. stored in memory location 00. This may following: Press MEM to store the number be a frequently dia
ملخص المحتوى في الصفحة رقم 14
TAKING CARE OF YOUR CHANGING STORED NUMBERS If your phone is connected to a PBX TELEPHONE. Your telephone has a durable plastic To change or replace a stored number, you can store the PBX access number Your VTech VT1900 cordless telephone casing that should retain its luster for simply store a new number in the and a pause before the phone number. contains sophisticated electronic parts, many years. Clean it only with a soft desired memory location following the For example, to store 9-P
ملخص المحتوى في الصفحة رقم 15
If the handset is moved to a point where NOISE OR INTERFERENCE YOU GET NOISE, STATIC,"OR -A If you have difficulty operating your the base and handset can no longer YourVTech VT1900cordless telephone WEAKSIGNAL EVEN WHENYOU'RE phone, the suggestions below should communicate, the handset will make a has auto-channel scan circuitry which solve the problem. If you still have NEAR THE BASE UNIT. " quick series of beeps to signal Out of will detect excess noise and change difficulty aftertry
ملخص المحتوى في الصفحة رقم 16
YOU HEAR OTHER CALLS WHILE LIMITED W USING YOUR PHONE. VTECH Communications warrants, to the original purchaser only, the material and Disconnect your base unit from the workmanship of this product for ONE YEAR from the date of purchase. VTECH telephone jack, and plug in a regular will repair or replace, at our option, this product without charge should it fail due telephone. If you still hear other calls, to a defect in material or workmanship within that time period. the problem is p
ملخص المحتوى في الصفحة رقم 17
FREQUENCY CONTROL SIZE Crystal Controlled Dual PLL Handset : 188 x 62 x 35mm VT1900 Synthesizer Cordless Base : 210x145~148 TRANSMIT FREQUENCY Telephone Handset: 925.05 MHz to 927.75 WEIGHT MHz (All ten channels Handset : 2829 within this range) Base : 4289 Base: 902.3 MHz to 905.0 MHz (All ten channels POWER REQUIREMENTS within this range) Handset : Self-contained nickel-cad- mium rechargeable battery RECE~VE FREQUENCY supply, 3.6V nominal, Handset: 902.3 MHz to 905.0 6OOmA
