ملخص المحتوى في الصفحة رقم 1
DRX402 Accessory Handset and
TM
MULTIRANGE Charger User's Guide
What's in the box?
DRX402 accessory handset with
TM
MULTIRANGE charger
AC
Belt clip
Battery
adapter
cover
(PS-0033)
Desk stand/
wall mount
Rechargeable
bracket (This may
battery pack
already be attached)
(BT-1018)
If any items are missing or damaged, contact our Customer
Care Line immediately. Never use damaged products!
Need Help? Get answers 24/7 at our website: www.uniden.com.
If You... Contact Uniden’s... Phone Numb
ملخص المحتوى في الصفحة رقم 2
What's in the manual? Important Safety Instructions! ... 2 Registering the TM MULTIRANGE charger ........... 7 Setting Up Your Handset ............3 TM Placing the MULTIRANGE Install the Battery ...................... 3 charger .................................... 8 Connect the Charger .................. 3 Wall Mounting the Registering the Handset ............ 4 TM MULTIRANGE charger ........... 9 Attaching the Belt Clip ............... 5 Using the Handset ..................... 5 Important In
ملخص المحتوى في الصفحة رقم 3
Setting Up Your Handset Install the Battery 1. Unpack the handset, battery pack, and battery cover. If the battery cover is already on the handset, press in on the notch and slide the cover down and off. 2. Line up the battery pack connector with the jack inside the handset. (The battery connector only fits one way.) 3. Push the battery pack connector in until it clicks into place. Tug gently on the wires to make sure the battery pack is securely connected. 4. Place the cover over
ملخص المحتوى في الصفحة رقم 4
3. Place the handset in the charger with the display facing forward. The CHARGE light should turn on. If... Try... the - reseating the handset. CHARGE - checking the AC adapter connection. light does - seeing if the outlet is controlled by a not turn on wall switch. Charge the handset completely (about 16 hours) before using it. Registering the Handset Registering the handset is a separate process from TM registering the MULTIRANGE charger. You can use the handset normally even if the ch
ملخص المحتوى في الصفحة رقم 5
2. O n t h e h a n d s e t , p r e s s a n d h o l d Pound (#) u n t i l t h e d i s p l a y says Handset Registering (abou t 2 seconds). After about 30 seconds, the handset display should say Registration Complete. Test the connection Pick up the handset and press Talk . Make sure you get a End dial tone. (Press to hang up.) If... Try... - you don't hear a dial tone Making sure the handset is - the display says fully charged, then trying again. Registration Failed Atta
ملخص المحتوى في الصفحة رقم 6
TM Using the MULTIRANGE Charger How It Works TM The DRX402 M U L T I R A N G E charger extends the range of your base in all directions, including up and down. Each handset will automatically connect to the charger or the base, depending on which signal is stronger. (The handset operates exactly the same way whether it's connected to the TM base or to the M U L T I R A N G E charger.) Base Coverage Area Handsets in this area always connect to the base. Overlap Coverage Base Area TM MU
ملخص المحتوى في الصفحة رقم 7
Each of these bases can support up to two DRX402 T M M U L T I R A N G E c h a r g e r s , i n c l u d i n g a n y t h a t w e r e s u p p l i e d with your phone. Usually, you can't tell when a handset switches between the base and the charger in the middle of a call, but sometimes, you might notice a brief pause in your conversation. TM Registering the MULTIRANGE charger TM Registering the MULTIRANGE charger is a separate process from registering the handset. You can u
ملخص المحتوى في الصفحة رقم 8
TM If you want to use the M U L T I R A N G E charger with a different base, just register the charger to the new base. The charger automatically erases the link to the old base when it registers to the new one. Only register the charger to one base at a time. If more than one base is in registration mode at the same time, you can't control which base the charger registers to. TM Placing the MULTIRANGE charger TM Here are a few tips for placing your M U L T I R A N G E charger
ملخص المحتوى في الصفحة رقم 9
3. Watch the signal strength icon on the handset. Make a note where the icon drops from 4 bars to 3 bars. 4. Continue walking away from the base. Make a note where the signal strength icon drops from 3 bars to 2 or if you start to hear noise on the line (which indicates the signal is getting weaker). 5. Place the charger anywhere inside the range where the signal strength icon showed 3 bars and the handset had a clear signal with no noise. Testing the location Connect the charger's AC
ملخص المحتوى في الصفحة رقم 10
3. Align the stand with the notches on the charger. 4. Slide the stand onto the notches until it clicks into place. 5. Insert two #10 screws into the wall, 30 mm apart. (For best results, use a level to ensure the screws are even.) Remember to use appropriate anchors for the wall material. 6. Keeping the AC adapter cord out of the way, place the charger over the screw heads and slide it down into place. Switching back to the desk stand If you want to switch back to using t
ملخص المحتوى في الصفحة رقم 11
Important Information Specifications Part number PS-0033 AC Adapter Input voltage 120V AC, 60 Hz Output voltage 6.5V AC @ 350mA Part number BT-1018 Battery pack Capacity 500mAh, 2.4V DC Use only the supplied AC adapter. Be sure to use the proper adapter for the base and any chargers. Do not place t he power cord where it creat es a t rip hazard or where it could become chafed and create a fire or electrical hazard. Do not place the unit in direct sunlight or subject
ملخص المحتوى في الصفحة رقم 12
With normal use, the battery should last about one year. Replace the battery when the talk time becomes short even when the battery is charged. To buy a replacement battery, call the Parts Department listed on the front cover. Rechargeable Nickel-Metal-Hydride Battery Warning CAUTION! Risk of explosion if battery is replaced by an incorrect type! Dispose of used batteries according to the instructions. Do not open or mutilate the battery. Disconnect the battery before shipping this pr
ملخص المحتوى في الصفحة رقم 13
Compliance Information Any changes or modifications to this product not expressly approved by the manufacturer or other party responsible for compliance could void your authority to operate this product. FCC Part 15 information This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired op
ملخص المحتوى في الصفحة رقم 14
The handset is designed for body-worn operation and meets FCC RF exposure guidelines when used with any belt clip, carrying case, or other accessory supplied with this product. (All necessary accessories are included in the package; any additional or optional accessories are not required for compliance with the guidelines.) Third party accessories (unless approved by the manufacturer) should be avoided as these might not comply with FCC RF exposure guidelines. Industry Canada (I.C.) Notice
ملخص المحتوى في الصفحة رقم 15
One-year Limited Warranty Important: Evidence of original purchase is required for warranty service. WARRANTOR: UNIDEN AMERICA CORPORATION ("Uniden") ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this Uniden Product to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below. WARRANTY DURATION: This warranty to the original user shall terminate and be of no further effect 12 months after the date of orig
ملخص المحتوى في الصفحة رقم 16
allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This warranty is void outside the United States of America and Canada. PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the owner's manual you are certain that the Product is defective, pack
