ملخص المحتوى في الصفحة رقم 1
ملخص المحتوى في الصفحة رقم 2
Precautions Before you read anything else, please observe the following: Warning! Uniden America Corporation DOES NOT represent this unit to be waterproof. To reduce the risk of fire, electrical shock, or damage to the unit, DO NOT expose this unit to rain or moisture. Rechargeable Nickel-Cadmium Battery Warning n This equipment contains a Rechargeable Nickel-Cadmium Battery. n Cadmium is a chemical known to the State of California to cause cancer. n The Rechargeable Nickel-Cadmium Battery conta
ملخص المحتوى في الصفحة رقم 3
Controls and Keys 1. Talk/Batt Low Indicator – talk • batt low 7. Flash Key – flash 2. Talk Key – talk 8. Pause Key – pause 3. Numeric Keypad 9. Volume Up (volume s) 4. Memory Key – mem 10. Volume Down (volume t) 5. Microphone 11. Page/Find Key – page/find 6. Redial Key – redial 12. Charge LED Indicator – status
ملخص المحتوى في الصفحة رقم 4
Contents Important Safety Instructions .....................................2 Introduction....................................................4 Features......................................................4 Included with the EXS9005 .......................................5 Important Electrical Considerations................................6 Range........................................................6 Telephone Line Problems .......................................6 Radio Interference .........
ملخص المحتوى في الصفحة رقم 5
Important Safety Instructions When using your telephone equipment, these basic safety precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wall outlet before cleaning. Use a dry cloth for cleaning without liquid or aerosol cleaners. 4. Do not use this product near water; for example, near a bath tub, wash bow
ملخص المحتوى في الصفحة رقم 6
12. Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: A. When the power supply cord is damaged or frayed. B. If liquid has been spilled into the product. C. If the product has been exposed to rain or water. D. If the product does not operate normally when following the operating instructions. (Adjust only those controls that are covered by the operating instructions. Improper adjustment of other controls may result in dama
ملخص المحتوى في الصفحة رقم 7
Introduction Congratulations on your purchase of the Uniden EXS9005 Cordless Telephone. This phone is designed to exacting standards that provide reliability, long life, and outstanding performance. Features ò 900 MHz Long-range ò Digital Spread Spectrum Technology ò 20 Channel Autoscan ò UltraClear Plus ò AutoTalk™ ò 20-Number Memory ò Redial, Flash and Pause ò AutoSecure™ ò Pulse/Tone Dialing ò AutoStandby™ ò 1-way Page/Find Button ò 7 Day Battery Life AutoTalk™ allows you to answer a call by
ملخص المحتوى في الصفحة رقم 8
men Now is to the come time to the foraid all of good the Now is the time for party. all good Four men score to yeas ago come to the aid o our f the fathers party. Four set forth a new score yeas ago nation our fathers conceived set in Liberty Liberty forth a new and nation dedicated proposition and conceived dedicated to that the in to all men the proposition that are created equal. The quick all men are created equal.brown The quick foxbrown jumped fox over the jumped over the fo4r garden
ملخص المحتوى في الصفحة رقم 9
Important Electrical Considerations Unplug all electrical appliances when you know an electrical storm is approaching. Lightning can pass through your household wiring and damage any device connected to it. This phone is no exception. Warning! Please do not attempt to unplug any appliance during an electrical storm. Caution: Changes or modifications to this product not expressly approved by Uniden, or operation of this product in any way other than as detailed by this Operating Guide, could void
ملخص المحتوى في الصفحة رقم 10
Radio Interference Radio interference may occasionally cause buzzing and humming in your cordless Handset, or clicking noises in the Base Unit. This interference is caused by external sources such as TV, refrigerator, vacuum cleaner, fluorescent lighting, or electrical storm. Your unit is NOT DEFECTIVE. If these noises continue and are too distracting, please check around your home to see what appliances may be causing the problem. In addition, we recommend that the Base Unit not be plugged into
ملخص المحتوى في الصفحة رقم 11
Installation Selecting a Location Before choosing a location for your new phone, there are some important guidelines you should consider: ò The location should be close to both a phone jack and continuous power outlet. (A continuous power outlet is an AC outlet which does not have a switch to interrupt its power.) ò Keep the Base Unit and Handset away from sources of electrical noise such as motors or fluorescent lighting. ò Be sure there is sufficient space to fully extend the Base Unit antenna
ملخص المحتوى في الصفحة رقم 12
Applying Power to the Base Unit This phone requires an AC outlet, without a switch to interrupt power, and the included AC adapter. To relieve strain on the DC plug when the phone is placed on a desk or table, connect the adapter as shown below. Wrap the power cord around the strain relief notch on the bottom of the Base Unit. Place the power cord so that it does not create a trip hazard, or where it j could become chafed and create a fire or other electrical hazards. Adapter Safety Feature The
ملخص المحتوى في الصفحة رقم 13
Desk or Tabletop Installation 1. Plug the AC Adapter cord into the 9 VDC input jack on the Base Unit. 2. Place the AC Adapter cord around the strain relief notch. 3. Plug one end of the long telephone cord into the TEL LINE jack on the Base Unit. 4. Plug the other end of the cord into the telephone jack on the wall. 10 EXS9005
ملخص المحتوى في الصفحة رقم 14
5. Plug the AC Adapter into a standard 120 VAC wall outlet. Do not use an outlet controlled by a wall switch. Use only the Uniden AC Adapter supplied with this phone. 6. Place the Base Unit on a desk or tabletop. In desk or table top installation, the Handset is designed to stand only vertically in the Base Unit. DO NOT lay the Handset down on the Base Unit. EXS9005 11 Installation
ملخص المحتوى في الصفحة رقم 15
Wall Installation Standard Wall Plate Mounting These phones are designed to be mounted on a standard AT&T or GTE wall plate. To attach the wall mount to the Base Unit: 1. Slide the wall mount into the notches at the top of the Base Unit. 2. Rotate the wall mount stand down and snap into place. 3. Plug the AC Adapter into the Base Unit. 12 EXS9005
ملخص المحتوى في الصفحة رقم 16
4. Wrap the AC Adapter cord around the strain relief notch. Then put the AC Adapter cord inside the molded channel. 5. Plug one end of the short telephone cord into the TEL LINE jack on the Base Unit. Place the telephone cord inside the molded channel on the bottom of the Base Unit. Then plug the other end of the telephone cord into the modular jack on the wall. 6. Place the Base Unit on the posts of the wall plate and push down until it’s firmly seated. EXS9005 13 Installation
ملخص المحتوى في الصفحة رقم 17
7. Plug the AC Adapter into a standard 120 VAC wall outlet. Do not use an outlet [ controlled by a wall switch. Direct Wall Mounting If you do not have a standard wall plate, you can mount your phone directly on a wall. Before mounting your phone, consider the following: ò Select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall. ò Make sure the wall material is capable of supporting the weight
ملخص المحتوى في الصفحة رقم 18
3. Rotate the wall mount stand down and snap into place. 4. Plug the AC Adapter into the Base Unit. 5. Wrap the AC Adapter cord around the strain relief notch. Then put the AC Adapter cord inside the molded channel. EXS9005 15 Installation
ملخص المحتوى في الصفحة رقم 19
6. Plug one end of the short telephone cord into the TEL LINE jack on the Base Unit. Put the cord inside the molded channel on the bottom of the Base Unit. 7. Place the Base Unit on the screws and push down until it’s firmly seated. 8. Plug the other end of the telephone line cord into the wall jack. 9. Plug the AC Adapter into a standard 120 VAC wall outlet. Do not use an outlet [ controlled by a wall switch. 16 EXS9005
ملخص المحتوى في الصفحة رقم 20
Setting Up Your Phone Raising the Antenna Before using your phone, be sure to raise its antenna to the vertical position. Installing the Handset Battery Pack 1. Press in on the Battery Cover Release and slide the battery compartment cover down. 2. Align the plastic connector of the Nickel-Cadmium battery pack with its socket and plug it in. The black lead will be on the left [ when the plug is properly aligned. 3. Place the battery pack inside the battery compartment and slide the battery cover
