ملخص المحتوى في الصفحة رقم 1
USER GUIDE
DECT1905
OPTIONAL HANDSET
TO SUIT MODELS
DECT 1915, DECT1955
DIGITAL CORDLESS
TELEPHONES
WITH SMS
MESSAGING
AND FULL
COLOUR
THIS EQUIPMENT IS NOT DESIGNED FOR
MAKING EMERGENCY TELEPHONE CALLS
WHEN THE POWER FAILS. ALTERNATIVE
ARRANGEMENTS SHOULD BE MADE FOR
ACCESS TO DIAL EMERGENCY SERVICES.
Before operating this set,
Ver. 1, Mar 05
please read these instructions carefully.
ملخص المحتوى في الصفحة رقم 2
Important note — emergency calls The DECT 1905 must be registered to a base series (DECT 1915 or DECT1955) before use and is not designed for making emergency calls when the mains power fails. So you should make alternative arrangements for access to Emergency Services. (This means that you should also have a basic phone that does not need mains power, connected to your line so that you can make calls during a power failure.) If you need help … Visit our websites for information; Australia:
ملخص المحتوى في الصفحة رقم 3
Read these notes first Choosing The charger pod(s) should be placed on a level surface, a site for the in a position where: charger pod ■ the mains adapter plug will reach an easily accessible 240-V AC switched mains supply socket — never try to lengthen the mains power cable ■ it is not close to another telephone — this can cause radio interference ■ it is not close to a sink, bath or shower, or anywhere else where it might get wet ■ it is not close to other electrical equipment — fridges, wash
ملخص المحتوى في الصفحة رقم 4
Installation and Set-up 1 Choose a suitable site for the charger pod. See page 3. Plug the mains adapter into a 240 V AC, 50 Hz mains socket, with the switch on the socket set to OFF See the note on page 3 2 Switch on at the mains socket Fit the rechargeable batteries in each handset 3 A. Fit the two batteries as shown, making sure you match the + and – ends to the markings in the battery compartment B. Fit the battery compartment cover, sliding it into place and pressing firmly to make sure it
ملخص المحتوى في الصفحة رقم 5
Installation and set-up Charge the batteries for 15 hours 4 Before you use the handset for the first time, it’s important to charge the batteries fully. The handset ‘beeps’ when it’s correctly in position on the charging cradle. Leave the handset on the charging cradle Battery charge for 15 hours. level symbol The battery charge level symbol should increase by one bar every half hour when you’re charging an empty battery. If you think that the symbol isn’t showing the correct battery charge leve
ملخص المحتوى في الصفحة رقم 6
BASIC USE Before you start Electrical ■ DON’T let the base unit or charger pod get wet. safety Electrical equipment can cause serious injury if used while you are wet or standing in water. ■ If the base unit or charger pod ever falls into water, DON’T retrieve it until you have unplugged the power lead from the mains and the telephone line plug from the telephone socket (base unit only); then pull it out by the unplugged cables. ■ NEVER use your DECT 1905 outdoors during a thunderstorm — unplug
ملخص المحتوى في الصفحة رقم 7
Handset registration You must register the DECT 1905 handset to a ! compatible base (DECT 1915 or DECT1955 series base) before use. To check whether a handset is already registered, make sure mains power to the base unit is switched on and the handset is within range. The handset’s display should show its name (default ) Handset and number. If the display constantly shows No base found, you need to register the handset. Each handset can be registered to up to four base units,
ملخص المحتوى في الصفحة رقم 8
Handset registration 7 Press the right Soft button [OK] u The display may flash Register for a few moments, while the handset searches for a base unit. It then shows a list of handset numbers for the base unit. 8 Key in a free handset number (optional) and press the right Soft button [OK] (If you don’t key in a number, the base will select one automatically.) u If registration is successful, the display returns to standby mode. To register Follow the steps as for re-registering, but at step 5, ◗
ملخص المحتوى في الصفحة رقم 9
Handset registration To select a If your handset is registered to more than one base unit base unit, it will automatically select the one with which it can best set up a radio link (usually the nearest one). Or you can select a base unit manually. You don’t need this function if you have only one base unit. 1 Press the right Soft button [Menu], then press the or button to scroll to Handset 2 Press the right Soft button [OK] 3 Press the or button to scroll to Select Base, then press the right
ملخص المحتوى في الصفحة رقم 10
Handset registration To register to Your DECT 1905 handset(s) can be registered to any a different GAP-compatible base unit. brand of base unit But we do not guarantee that all features or display messages will be available using other manufacturers’ equipment. 1 Follow the instructions in the base unit’s User Guide to put the base unit into registration mode. 2 Follow the instructions to register the handset (Steps 2 to 5 on page 7). If you need to enter a PIN code for the base unit, refer to t
ملخص المحتوى في الصفحة رقم 11
Warranty One Year Limited Warranty Important: Evidence of original purchase is required for warranty service. Warrantor: Uniden Australia Pty Limited. ABN 58001 865 498 Uniden New Zealand Limited ELEMENT OF WARRANTY: Uniden warrants to the original retail owner for the duration of this warranty, its DECT 1905 (herein after referred to as the Product), to be free from defects in materials and craftmanship with only the limitations or exclusions set out below. WARRANTY DURATION: This warranty
