ملخص المحتوى في الصفحة رقم 1
NetLink e340/h340/i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol (SRP)
Configuration and Administration
Part Number: 72-1065-09
Issue J
ملخص المحتوى في الصفحة رقم 2
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol Notice SpectraLink Corporation has prepared this document for use by SpectraLink personnel and customers. The drawings and specifications contained herein are the property of SpectraLink and shall be neither reproduced in whole or in part without the prior written approval of SpectraLink, nor be implied to grant any license to make,
ملخص المحتوى في الصفحة رقم 3
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol Note concerning the NetLink Wireless Telephones: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. TUV Rhein
ملخص المحتوى في الصفحة رقم 4
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol Table of Contents 1. About This Document 5 1.1 SpectraLink Corporation Model Numbers 5 1.2 Related Documents 5 1.3 Customer Support Hotline 5 1.4 Icons and Conventions 5 2. NetLink Wireless Telephone Overview 6 2.1 SpectraLink Voice Priority (SVP) 6 2.2 QoS and Security 6 2.3 Quick Start Guide 7 2.4 NetLink Wireless Telephone
ملخص المحتوى في الصفحة رقم 5
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol 1. About This Document This document explains how to configure and maintain the NetLink e340, h340 and i640 Wireless Telephones (handsets) when used with the NetLink Telephony Gateway. 1.1 SpectraLink Corporation Model Numbers This document covers the following registered model numbers: SNP2400, RNP2400 1.2 Related Documents Spec
ملخص المحتوى في الصفحة رقم 6
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol 2. NetLink Wireless Telephone Overview The NetLink e340, h340 and i640 Wireless Telephones are mobile handsets for workplace telephone systems. The handset operates over an 802.11b wireless Ethernet LAN providing users a wireless voice over IP (VoIP) extension. By seamlessly integrating with the NetLink Telephony Gateway and the site
ملخص المحتوى في الصفحة رقم 7
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol The NetLink e340/h340/i640 Wireless Telephones support Wired Equivalent Privacy (WEP) as defined by the 802.11 specification. SpectraLink offers the product with both 40-bit and 128-bit encryption. NetLink Wireless Telephones also support the 802.11i protocol including Wi-Fi Protected Access (WPA and WPA2) pre-shared key (PSK). As v
ملخص المحتوى في الصفحة رقم 8
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol 2.4 NetLink Wireless Telephone Specifications 1 NetLink e340/h340 Wireless Telephone NetLink i640 Wireless Telephone Radio frequency 2.4000 – 2.4835 GHz Transmission type Direct sequence spread spectrum (DSSS) Transmit data rate Up to 11 Mb/s Radio QoS SpectraLink Voice Priority (SVP), WMM Wireless security Wired Equivalent Privac
ملخص المحتوى في الصفحة رقم 9
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol 2.5 Handset Display See the LinkPlus Interface Guide for your PBX for information about how the handset emulates the features of the PBX utilized at your site. The following general explanations may not apply due to differences in PBX configurations. Alphanumeric Display information provided by the PBX when the handset is off-hook
ملخص المحتوى في الصفحة رقم 10
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol handset will follow the protocol command provided by the PBX if the user selects PBX cadence described in section 3.2 User-defined Preferences. Audio features Speaker-phone features are not available on the handset unless using the NetLink Docking Station. Line indicators The Line Indicator bullets on the handset will convert to a
ملخص المحتوى في الصفحة رقم 11
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol 2.7 Handset Modes Standby (on-hook) In the standby mode the handset is waiting for an incoming call or for the user to place an outgoing call. The extension number is shown on the display and there is no dial tone. In this mode, the handset is conserving battery power and wireless LAN bandwidth. When an incoming call occurs the han
ملخص المحتوى في الصفحة رقم 12
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol 2.8 Handset Displays Status display Displays information from the PBX in two lines of text and displays available softkeys in the softkey display area. The PBX text may be truncated as some PBXs send 24 characters and the handset display area is 16 characters. LINE display Most, but not all, PBXs allow for more than one line appear
ملخص المحتوى في الصفحة رقم 13
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol 3. NetLink Wireless Telephone Configuration Prior to configuring a NetLink e340, h340, or i640 Wireless Telephone, it must be associated with one and only one line on one of the NetLink Telephony Gateways. Then it must be configured per the instructions in this section. The following instructions assume that the handset has been prop
ملخص المحتوى في الصفحة رقم 14
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol Entering and editing Admin menu options An asterisk (*) next to an option on the display indicates that the option is selected. Use the Up, Down, and Select side buttons and the softkeys to navigate and select: Display previous/next menu item. Up/Down buttons: Selects the menu item or option. Select button: Selects the menu item o
ملخص المحتوى في الصفحة رقم 15
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol Admin menu nd rd th th Admin Menu Items 2 Level 3 Level 4 Level 5 Level Phone Config License Option Set Current [List per download] Push-to-talk Enable Channels *Channel 1 *Channel 2 *Channel 3 *Channel 4 *Channel 5 *Channel 6 *Channel 7 *Channel 8 Allow/Disallow *Allow PTT Disallow PTT Admin Password Enter PW Re-ent
ملخص المحتوى في الصفحة رقم 16
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol Phone Config License Option License Option lets you select the VoIP protocol that your site is licensed to download and run. The SpectraLink Radio Protocol (SRP) used for the NetLink e340/h340/i640 Wireless Telephones in a NetLink Telephony Gateway system requires License Option Selection 007. Any other protocol will cause the hands
ملخص المحتوى في الصفحة رقم 17
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol components on a different subnet. If configured on the DHCP server, use option 3 for the Default Gateway and option 1 for the Subnet Mask. Contact your network administrator for the proper settings for your network. NetLink Wireless Telephones cannot roam with uninterrupted service between subnets unless specific LAN components are p
ملخص المحتوى في الصفحة رقم 18
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol For WEP, WPA-PSK and WPA2 PSK set each of the following options to match exactly the settings in your APs. Encryption codes display as they are entered. For security reasons codes will not display when a user returns to encryption options in the Admin menu. WEP (Wired Equivalent Privacy) A wireless encryption protocol that encr
ملخص المحتوى في الصفحة رقم 19
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol WPA-PSK The security features of WPA (Wi-Fi Protected Access) using PSK (pre- shared key) are available and may be used if supported by the access points in the facility. Select either Passphrase and enter a passphrase between 8 and 63 characters in length or Direct Entry and enter the 256-bit key code. WPA2-PSK The security feature
ملخص المحتوى في الصفحة رقم 20
SpectraLink Corporation Configuration and Administration–NetLink e340/h340/ i640 Wireless Telephone NetLink Telephony Gateway and SpectraLink Radio Protocol Restore Defaults The Restore Defaults option will set all user and administrative parameters except License Option to their factory defaults. 3.2 User-defined Preferences The following user-defined preferences are also covered in the NetLink e340/h340/i640 Wireless Telephone user guides. The system administrator can refer to this l
