Summary of the content on the page No. 1
Radio-controlled Outdoor Wall Clock
INTRODUCTION
with Thermometer
Thank you for selecting the Oregon Scientific™ JM888
Radio-controlled Outdoor Wall Clock with Thermometer
Model: JM888
as your product of choice.
USER MANUAL
This product is splash-proof and targeted for outdoor
usage, ideal for places such as a golfcourse clubhouse,
pool-side terrace, restaurant patio, garden shed, outdoor
USER MANUAL CONTENTS terrace, veranda or balcony.
Introduction .............................................
Summary of the content on the page No. 2
KEY FEATURES FRONT VIEW 1. Rubber ring 1 2. Transparent cover lens 2 BACK VIEW 1. Temperature sensor 2. Wall-mount recess hole - For mounting the unit to a 1 wall 3. Table stand - Can be pulled out and used to stand the unit on a flat surface 4. Battery compartment - The unit uses 2 AA/UM-3 2 1.5V batteries for power 5. MODE button -Toggles between the clock display modes and can manually adjust current time and date 4 6. UP / DOWN buttons - To adjust settings up or down 3 one notch or to enable
Summary of the content on the page No. 3
To load the batteries: LCD DISPLAY SYMBOLS 1. Locate the battery compartment. 1 2. Unscrew the four small screws from the battery 2 compartment. 3. Install the batteries by matching the correct polarity. Always use the correct battery type (2 x UM-3 AA- sized 1.5V batteries). 3 WARNING Reversing the polarity may damage the product. 4 NOTE Replace the batteries whenever the low 5 9 6 battery icon is shown, the display is dim, or the display does not illuminate when the power is on. Replace all t
Summary of the content on the page No. 4
NOTE ON WHERE TO PLACE THE UNIT ENABLING / DISABLING RECEPTION This unit is designed for outdoor usage. To manually disable the reception of the radio clock signal, press and hold the DOWN button for 2 seconds. When the unit is relocated from one place to another in (The radio reception signal will not appear on the LCD extreme temperatures (e.g. from a very hot area to a very display). cold one), water condensation may occur on the lens at the front. This will not affect the functions of the u
Summary of the content on the page No. 5
CHANGING CELSIUS TO FAHRENHEIT GETTING STARTED The sensor range is up to 30 meters (100 feet) with no To change Celsius to Fahrenheit: obstructions. Simply slide the switch at the back of the clock from °C to °F. (This switch is located inside the battery compartment). SEARCHING AND DISPLAYING THE UV DATA To begin searching for remote signals from the UV sensor, press and hold both the UP and DOWN buttons THE RESET HOLE simultaneously for more than 2 seconds. (The lower left If the clock behaves
Summary of the content on the page No. 6
Power supply TROUBLESHOOTING GUIDE 2 x UM-3 / AA 1.5V batteries BASIC FUNCTIONS Temperature unit This section includes a list of frequently asked questions °C or °F for problems you may encounter. If your device is not operating as you think it should, check here before Temperature measuring range arranging for servicing. -20 °C to 60 °C (-4 °F to 140 °F) Problem: Radio antenna is not displayed on the LCD screen. Symptom: The RF signal cannot be received. WARNINGS Check this: Obstacles (either e
Summary of the content on the page No. 7
ABOUT OREGON SCIENTIFIC EC-DECLARATION OF CONFORMITY Visit our website (www.oregonscientific.com) to learn This product contains the approved transmitter module more about Oregon Scientific products such as digital that complies with the essential requirements of Article cameras; MP3 players; children’s electronic learning 3 of the R&TTE 1999 / 5 / EC Directive, if used as products and games; projection clocks; health and fitness intended and the following standards have been applied: gear; weat
Summary of the content on the page No. 8
Radio-controlled Outdoor Wall Clock with Thermometer Model: JM888 User Manual 8 JM888_EN_R8 8 9/3/04, 6:33 PM EN
Summary of the content on the page No. 9
2004 Oregon Scienfitic. All rights reserved. P/N: xxx-xxxxxx-xxx 9 JM888_EN_R8 9 9/3/04, 6:33 PM EN
