Summary of the content on the page No. 1
TSS-Sub500
(TSS-500 SYSTEM)
SERVICE MANUAL
Infinity Systems Incorporated
250 Crossways Park Dr.
Woodbury, New York 11797 Rev0 6/2006
Summary of the content on the page No. 2
TSS-Sub500 Note: The TSS-Sub500 is part of the TSS-500 system Satellite loudspeakers: (Charcoal) order Infinity part# TSS-SAT500CHR (Platinum) order Infinity part# TSS-SAT500PLT Center channel: Call Infinity Systems parts department (Charcoal) (Platinum) CONTENTS BASIC SPECIFICATIONS . . . . . . . . . ………………….………….... .. . . . . . 1 PACKAGING/ACCESSORIES. . . . . . . . . . . . . . . . . .………. . .. .. ... . . . . . 2 DETAILED SPECIFICATIONS
Summary of the content on the page No. 3
TSS-Sub500 TSS-500 PACKING/ACCESSORIES Item # Description Part Number Qty 1 Warranty Card 405-000-05110-E 1 2 Owner’s Manual 406-000-05307-E 1 3 Packing Not for Sale 1 4 Packing Bag Not for Sale 4 5 Inner Carton Not for Sale 1 6 Packing Bag Not for Sale 1 7 Nut wrench (metal bar) 399-FE-00630-E 1 8 15’ RCA cable 370-000-00273-E 1 9 Rubber feet for stands (Platinum) 373-000-05051-E 1 Rubber feet for stands (Charcoal) 373-000-05050-E 1 10 Screw
Summary of the content on the page No. 4
TSS-Sub500 TSS-Sub500 100W Powered Sub/ Plate Amp LINE VOLTAGE Yes/No Hi/Lo Line Unit Notes US 120VAC/60Hz Yes 108-132 Vrms Normal Operation Europe 220-240VAC, 50-60Hz Yes 220-240 Vrms Normal Operation Parameter Specification Unit QA Test Limits Conditions Notes Amp Section Type (Class AB, D, other) AB AB n/a 120V Model External Sink required Type (Class AB, D, other) G G n/a 230V Model External Sink required Load Impedance (speaker) 4 Ohms n/a Nominal Rated Ou
Summary of the content on the page No. 5
TSS-Sub500 Parameter Specification Unit QA Test Limits Conditions Notes Protection Short Circuit Protection YES -- Functional Direct short at output Temperature rise should not exceed 35K Thermal Protection 65 deg. C -- Functional @1/8 max unclipped Power rise DC Offset Protection YES -- Functional DC present at Speaker Out leads Relay or crowbar (for driver/fire protection) Line Fuse Rating External fuse with UL/SEMKO rated holder Type-T or Slo Blo, Fuse Marking
Summary of the content on the page No. 6
TSS-500 OM 1/20/06 2:45 PM Page 8 TSS-Sub500 SUBWOOFER CONTROLS ¡ Rear Panel A Few Suggestions We recommend that you do not operate your speakers or subwoofer with the bass, treble and loudness controls set to £ ™ full boost.This will place undue strain on your electronics and speakers and could damage them. The volume control setting on your processor/preamp or receiver is not a specific indication of the overall loudness level of the speakers.The only import
Summary of the content on the page No. 7
TSS-500 OM 1/20/06 2:45 PM Page 9 TSS-Sub500 SUBWOOFER CONNECTIONS ® ® If you have a Dolby Digital or DTS receiver/ If your receiver/processor does not contain processor with a low-frequency-effects (LFE) a Dolby Digital or DTS processor but has a or subwoofer output: subwoofer output: 15' (4.6m) subwoofer cable included RECEIVER/PROCESSOR 15' (4.6m) subwoofer SUBWOOFER OR LFE OUTPUT cable included NOTE: If your receiver/processor has only one sub out, you ma
Summary of the content on the page No. 8
TSS-500 OM 1/20/06 2:45 PM Page 10 TSS-Sub500 OPERATION enhance bass, extending the response of the entire system so Surround Modes the bass can be felt as well as heard. However, overall balance When using the TSS-500 in a Dolby Digital or DTS home theater must be maintained or the music will not sound natural.An system, make sure all speakers are set to “Small” . When using the ® experienced listener will set the volume of the subwoofer so its system in a Do
Summary of the content on the page No. 9
TSS-Sub500 8
Summary of the content on the page No. 10
TSS-Sub500 Test Set Up and Procedure Equipment needed: • Function/signal generator/sweep generator • Integrated Amplifier • Multimeter • Speaker cables General Unit Function (UUT = Unit Under Test) 1) From the signal generator, connect one line level (RCA) cable to the Subwoofer Line Level Input jacks L/R on the UUT. Use a Y-cable from a mono source if necessary to connect to both inputs. Do not connect to the single LFE input. 2) On the fron
Summary of the content on the page No. 11
TSS-Sub500 10
Summary of the content on the page No. 12
TSS-Sub500 TSS500 Troubleshooting Flow Chart AMP no signal out no Check fuse, transformer, yes D110,D115 etc DC voltage check ±Vcc yes yes no Check Q117,118,119,D109 etc Check +/-15v yes yes LED red Led light blue or red Check,Q203,207,U203 etc LED light blue yes yes Check U201,R226,223 , Check U201 no U202,R213,214,C206 Check U202 pin14 signal pin14 signal etc y
Summary of the content on the page No. 13
TSS-Sub500 12
Summary of the content on the page No. 14
TSS-Sub500 13
Summary of the content on the page No. 15
TSS-Sub500 14
Summary of the content on the page No. 16
TSS-Sub500 15
Summary of the content on the page No. 17
TSS-Sub500 16
Summary of the content on the page No. 18
TSS-Sub500 17
Summary of the content on the page No. 19
TSS-Sub500 18
Summary of the content on the page No. 20
TSS-Sub500 19
