Summary of the content on the page No. 1
Model FM 1000
Electronic & Media Air Cleaner
Installation
Operation
Service
Please read these instructions carefully for
trouble free operation and to get the most out of
your purchase. For further information
concerning this project, contact your local Trion
representative
101 McNeill Road • Sanford, NC 27330
Phone: 800-884-0002 • Fax: 800-458-2379 • Email: sales@trioninc.com
www.trioninc.com
Manual Part No. 140627-001 • June 2002
Summary of the content on the page No. 2
to change the filter and wash the pre-filter. (From 1 to 4 SPECIFICATIONS months, depending on the application). FM 1000 Electrostatic The media main filter and charcoal after-filter are disposable when dirty. Replace with new filters from your Input Voltage: 120 V, 60 HZ, 1 PH authorized Trion Representative. Amp Draw: 3.1 Max. Unit Weight: 108 lbs. OPERATION Air Output: 600, 800 and 1100 CFM (nominal) CONTROL SWITCH Options: 1. Charcoal After Filter 2. Remote Discharge The 3 position control s
Summary of the content on the page No. 3
3. Open Filter access door and remove it. Also remove both collector cells or media filter and set aside being careful not to damage either. 4. Install eyebolts provided with unit as shown in Sketch A. CAUTION: DO NOT ALLOW FULL WEIGHT OF UNIT TO REST ON T-BAR CEILING. 8. Install mounting trim brackets to each side to fill in the gap between the unit and T-Bar. 9. Connect electrical power to the unit. See Wiring Diagram. 10. If optional carbon filter is used, remove filter from plastic bag and i
Summary of the content on the page No. 4
will notice a light film, then a very definite collection will input line voltage. A minimum voltage of 108 VAC is be evident at a later examination. When there is a required. noticeable build-up of dirt, it is time to wash. After assembling and installing the unit, turn the control In most areas the collecting cell should be washed every switch to one of the 3 positions. 12 weeks. 1. The unit’s green “on” light should now be on indicating the unit has line voltage. NOTE: 2. The voltage to the c
Summary of the content on the page No. 5
TROUBLESHOOTING PROBLEM SOLUTION 1. Check 120 VAC input power Unit does not operate 2. Broken lead in power cord Light not on 3. Bad speed controller 1. Broken wire between the speed controller Light on and the motor Blower does not run 2. Bad motor capacitor 3. Bad motor 5
Summary of the content on the page No. 6
6
Summary of the content on the page No. 7
FM 1000 E & M Unit Assembly Parts List Item Part Number Description 1 440549-001 Discharge grill (2 req.) 2 227833-006 Charcoal afterfilter (2 req.) 3 228276-001 Switch, 3 speed rotary 4 139999-001 Knob, switch 4A 244223-001 Label, control switch ESP (not shown) 4B 244224-001 Label, control switch Media (not shown) 5 240550-001 Pre-filter, aluminum mesh 6 120034-506 Machine screw (2 req.) 7
Summary of the content on the page No. 8
6A 244225-004 Retainer (2 req.) 6B 120456-001 Nylon Washer (2 req.) (not shown) 7 440541-001 Access door 8 422086-504 Ionizer/collector cell (electrostatic) 9 340553-001 Pleated media filter (Media) 10 140551-001 4 blade fan (electrostatic) 10A 140552-001 5 blade fan (Media) 11 240537-001 Collector cell latch 12 340623-001 Motor 13 234458-006 High voltage contact board assy. (2 req) 14 341677-601F Circuit board power supply 15 134516-013 LED light assy. (red electrostatic) 16 134516-007 LED ligh
Summary of the content on the page No. 9
9
Summary of the content on the page No. 10
10
Summary of the content on the page No. 11
11
Summary of the content on the page No. 12
FM 1000E Wiring Diagram 12
Summary of the content on the page No. 13
13
Summary of the content on the page No. 14
FM 1000M Wiring Diagram 14
Summary of the content on the page No. 15
WARRANTY All Trion air cleaners are warranted for component failure and workmanship for a period of three years after purchase. Do not return defective parts without prior permission from the factory. Contact your local Trion Distributor or Trion Customer Service Department at 1-800-884-002 of Fax 1-800-458-2379 to obtain material return authorizations and service information. Corporate Office: 101 McNeill Road • Sanford, NC 27330 Form No. 147527-001 Phone: 800-884-0002 • Fax: 800-458-237
